Black & Decker NHT518 Save These Instructions, Ext nsion Cord, volts, amperes, hertz, watts

WARNING: To reduce the risk of electrical shock; do not expose to rain, do not use on wet surfaces. Store indoors.

SAVE THESE INSTRUCTIONS

	WARNING: Some dust created by this product
contains chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm. Some examples of these
chemicals are:
	• compounds in fertilizers
	• compounds in insecticides, herbicides and pesticides
	• arsenic and chromium from chemically treated lumber
To reduce your exposure to these chemicals, wear approved safety
equipment such as dust masks that are specially designed to filter out
microscopic particles.
The label on your tool may include the following symbols.
V	volts	A		amperes
Hz	hertz	W		watts
min	............minutes	no		alternating current
	..........direct current			no load speed
..	............Class II Construction		..................	earthing terminal
	............safety alert symbol	.............../min		revolutions
				per minute

Makesure your extension cord is in good condition. When using an
Ext nsion Cord
extension cord be sure it is heavy enough to carry the current your
product will draw. An undersized extension cord will cause a drop in
line voltage resulting in loss of power and overheating. The following
table shows the correct size to use depending on cord length and
nameplate ampere rating. If in doubt, use the next heavier gauge.
The smaller the gauge number, the heavier the cord.
	Volts			Minimum Gage for Cord Sets
				0-25	Total Length of Cord in Feet
	120V				26-50	51-100	101-150
	240V			(0-7,6m) (7,6-15,2m)(15,2-30,4m)(30,4-45,7m)
				0-50	51-100	101-200 201-300
	Ampere Rating			(0-15,2m)(15,2-30,4m)(30,4-60,9m)(60,9-91,4m)
	More		Not more		American Wire Gage
	Than	-	Than	18	16	16	14
	0		6
	6	-	10	18	16	14	12
	10	-	12	16	16	14	12
	12	-	16	14	12	Not Recommended

DoubleoubleinsulatedInsulatitoolsnare constructed throughout with two separate layers of electrical insulation or one double thickness of insulation between you and the toolʼs electrical system. Tools built with this insulation system are not intended to be grounded. As a result, your tool is equipped with a two prong plug which permits you to use extension cords without concern

for maintaining a ground connection. Double insulation does not take the place of normal safety precautionsNOTE: when operating this tool. The insulation system is for added protection against injury resulting from a possible electrical insulation failure within the tool. REPLACEMENT PARTS:When servicing all tools, USE IDENTICAL REPLACEMENT PARTS. Repair or replace damaged cords.

4