Black & Decker NHT518 Operation, Leaving The Batterypack In The Charger, Storage Recommendation

Models: NHT518

1 40
Download 40 pages 27.66 Kb
Page 8
Image 8
LEAVING THE BATTERYPACK IN THE CHARGER

+40°F(+4.5°C), or above +105°F (+40.5°C). This is important and will prevent serious damage to the battery pack. Longest life and best performance can be obtained if battery pack is charged when air temperature is about 75°F (24°C).

3. While charging, the charger may hum and become warm to touch. This is a normal condition and does not indicate a problem.

4. If the battery pack does not charge properly—(1) Check current at receptacle by plugging in a lamp or other appliance. (2) Check to see if receptacle is connected to a light switch which turns power off when you turn out the lights. (3) Move charger and battery pack to a surrounding air temperature of 40°F (+4.5°C) to 105°F (+40.5°C). (4) If the receptacle and temperature are OK, and you do not get proper charging, take or send the battery pack and charger to your local Black & Decker service center. See Tools Electric in yellow pages.

5. The battery pack should be recharged when it fails to produce sufficient power on jobs which were easily done previously. DO NOT CONTINUE using unit with its battery pack in a depleted condition.

6. The battery pack will reach optimum performance after being

LEAVING THE BATTERYPACK IN THE CHARGER

It is OK to leave battery packs on charge for long periods of time. The charger has a maintenance mode which gives the battery pack enough charge to stay “topped off”. If however, the tool is not expected to be needed for more than 30 days, unplug the charger and store battery pack in a cool, dry location. NOTE: A battery pack will lose its charge when kept off of the charger. If the battery pack has not been kept on maintenance charge, it may need to be recharged before use. A battery pack may also lose its charge if left in a charger that is not plugged into an appropriate AC source.

OPERATION

SWITCHToturn the unit “ON”, slide the lock off button, 4

shown in , forward and, squeeze the trigger switchfigure. Once4 the unit is running, you may release the lock off button. In order to keep the unit running you must continue to squeeze the trigger. Toturn the unit “OFF”, release the trigger.

batterycycled 5packtimesdownduringcompletelynormal usage.beforeThererecharging.is no needNormalto runusagethe is the best method of discharging and recharging the battery pack.

STORAGE RECOMMENDATION

1. Store tool:

a.) with the battery pack removed and on the charger.

b.) ina placethatis coolanddryawayfromdirectsunlightandexcess heatorcold.

c.) out of the reach of children.

2. For prolonged storage such as over the winter, the battery pack should be fully charged and then removed from the charger. It should be charged again just prior to use.

TRIMMING1.INSTRUCTIONSMaintain properWORKINGfootingPOSITIONand balanceand do not overreach. Wear safety goggles, non-skid footwear and rubber gloves when trimming. Hold the unit firmly in both hands and turn the unit ON. Always hold the trimmer, as shown in the illustrations in this manual, with one hand on the switch handle and one hand on the bail handle.

Never hold the unit by the blade(figureguard5) .

8

5

Page 8
Image 8
Black & Decker NHT518 instruction manual Operation, Leaving The Batterypack In The Charger, Storage Recommendation