5. Follow the procedures in
After Working Inside Your Computer
.
Removing the Coin-Cell Battery
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove:
a) SD card
b) battery
c) base cover
d) keyboard trim
e) keyboard
f) palmrest
3. Remove the screw that secures the coin-cell battery to the system board.
4. Perform the following steps as shown in the illustration:
a) Lift the latch that secures I/O cable to the computer [1].
b) Disconnect the I/O cable from the system board [2].
5. Disconnect the coin-cell battery cable from the system board. Unroute the cables from the slot and remove the
coin-cell battery from the computer.
Installing the Coin-Cell Battery
1. Place the coin-cell battery in its slot.
2. Route the cables and connect the coin-cell battery cable to the system board.
3. Connect the I/O cable to the system board.
4. Tighten the screw that secures the coin-cell battery to the system board.
5. Install:
a) palmrest
b) keyboard
c) keyboard trim
d) base cover
e) battery
f) SD card
6. Follow the procedures in
After Working Inside Your Computer
.
22