6
A. Handle Module
B. Trimmer Head Module
1. Trigger Switch
2. Lock Button
3. Battery
4. Foam Gripper
5. Threaded Pole
6. Threaded Sleeve
7. Locking Latch
8. Hand Guard
9. 5 Position Head
10. Trimmer Blade
11. Blade Sheath
Assembly

Joining Trimmer Head Module to Handle Module

WARNING: Sharp moving blade. To prevent accidental
operation, insure that battery is disconnected from the handle
and that the protective blade sheath is in place on the blade
before performing the following operations. Failure to do this
could result in serious personal injury.
Combining the handle module (A) to the trimmer head module (B)
creates a pole trimmer that is approximately 6 foot in length as shown
in figure 3.
To attach the handle module to the
trimmer head module:
1. Align the groove on the outside of
the coupling end of the handle
module (A) with the tongue on the
inside of the coupling end of the
trimmer head module (B). See figure
4. Push the two sections completely
together.
2. Slide the threaded sleeve (6) figure 5
on the trimmer head module down as
far as possible and rotate the sleeve
clockwise until it stops and completely
covers the orange threads as shown
in figure 6.
WARNING: Always check to make
sure that the sleeve is completely
threaded on and that the orange
threads are no longer visible. Not
threading the sleeve completely on could result in the modules
becoming disconnected creating a hazardous condition.
Periodically check the connections to insure that no orange threads
are visible.
Groove
4
5
6
3

Transporting the Pole Trimmer

Always remove the battery from the
handle (figure 2) and cover the blade
with the blade sheath when transporting
the Pole Trimmer. See page 4 for
additional information on transporting
the battery.
2
Features
Before using your Pole Trimmer familarize yourself with all operating
and safety features.
A
1
2
3
4
5
6
7
8
B
9
10
11
629050-00 NPT318 Pole Trimmer 12/14/04 2:12 PM Page 6