7
Disassembly

Detaching Trimmer Head Module

WARNING: Sharp moving blade. To prevent accidental
operation, insure that battery is disconnected from the handle
and that the protective blade sheath is in place on the blade
before performing the following operations. Failure to do this
could result in serious personal injury.
When detaching the modules rest the handle module
on the ground and grasp the center of the trimmer
head module with one hand figure 7. Use your other
hand to loosen the
threaded sleeve figure 8
and then pull the two
halves apart.
Operating the Pole Trimmer
WARNING: Read and understand all instructions.Failure to
follow all instructions listed below may result in electric shock, fire
and/or serious personal injury.

Connecting the Battery

Place the battery in the tool as shown in figure 9 and be certain that it
is inserted fully into the tool cavity until it “clicks” into place. To remove
the battery from the tool, press down on the release button on the
back of the battery (figure 10) and slide out.

Pivoting the Trimmer Head

The trimmer head pivots 180 degrees and can be locked into 5
different positions within that range. To avoid being pinched, wear
gloves and hold unit as shown below.
Before connecting the battery to the unit, be sure the trimmer head is
locked into position.
To pivot the trimmer head:
1. Press in on the locking latch (7)
and raise the trimmer head as
shown in figure 11.
2. Lock the trimmer head into any of
the 5 positions. Check to make
sure that the trimmer head is
locked into position by trying to
move the motor housing. If it is not
locked, rotate it to the closest lock
position.

Operating Positions

With its unique design the Pole Trimmer can be used to trim and
shape hard to reach areas of hedges and bushes such as those
shown in figures 12 and 13.
7
8
10
9
11
12 13
629050-00 NPT318 Pole Trimmer 12/14/04 2:12 PM Page 7