Assembly
Joining Trimmer Head Module to Handle Module 
WARNING: Sharp moving blade. To prevent accidental
operation, insure that battery is disconnected from the handle and that the protective blade sheath is in place on the blade before performing the following operations. Failure to do this could result in serious personal injury.
Combining the handle module (A) to the trimmer head module (B) creates a pole trimmer that is approximately 6 foot in length as shown in figure 3.
3 |
|
To attach the handle module to the trimmer head module: | |
1. Align the groove on the outside of | 4 |
the coupling end of the handle |
|
module (A) with the tongue on the |
|
inside of the coupling end of the | Groove |
trimmer head module (B). See | |
figure 4. Push the two sections |
|
completely together. |
|
2. Slide the threaded sleeve (6) figure 5 5 | |
on the trimmer head module down as |
|
far as possible and rotate the sleeve |
|
clockwise until it stops and completely |
|
covers the orange threads as shown |
|
in figure 6. | 6 |
WARNING: Always check to make |
|
sure that the sleeve is completely |
|
threaded on and that the orange |
|
threads are no longer visible. Not |
|
threading the sleeve completely on |
|
could result in the modules becoming disconnected creating a | |
hazardous condition. Periodically check the connections to insure | |
that no orange threads are visible. |
|
Disassembly |
|
Detaching Trimmer Head Module | |
WARNING: Sharp moving blade. To prevent accidental | |
operation, insure that battery is disconnected from the handle | |
and that the protective blade sheath is in place on the blade | |
before performing the following operations. Failure to do this | |
could result in serious personal injury. | |
When detaching the modules rest the handle module 7 | |
on the ground and grasp the center of the trimmer | |
head module with one | 8 |
hand figure 7. Use your |
|
other hand to loosen the |
|
threaded sleeve figure 8 |
|
and then pull the two |
|
halves apart. |
|
Operating the Pole Trimmer | |
WARNING: Read and understand all instructions. Failure to | |
follow all instructions listed below may result in electric shock, fire | |
and/or serious personal injury. | |
Connecting the Battery | |
Place the battery in the tool as shown in figure 9 and be certain that it | |
is inserted fully into the tool cavity until it “clicks” into place. To | |
remove the battery from the tool, press down on the release button | |
on the back of the battery (figure 10) and slide out. | |
9 | 10 |
7
