How to Use
This appliance is for household use only.
BEFORE FIRST USE
Note: Time display will flash when you plug in your coffeemaker. You may set clock before, during or after brewing. (See SETTING THE CLOCK/TIMER.) You do not need to set clock before manual brewing. It is only absolutely necessary to set the clock if you are using the auto brew function.
•Grasp the integrated handle on the water reservoir and pull out from coffeemaker; remove lid to make filling easier. Fill carafe with 6 cups of fresh water and fill reservoir. Replace water reservoir with lid and carafe.
•Brew through the system, using an 8 – 12 cup
•Once water has brewed through, press ON/OFF button.
•Clean water reservoir, brew basket, carafe and lid. (See CARE AND CLEANING.)
BREWING COFFEE
1.Grasp handle and pull to remove the brew basket. Place an 8 – 12 cup
2.Grasping integrated handle, pull out water reservoir. Fill carafe with cold water to desired water level and pour into reservoir; the lid of the reservoir may be removed to make pouring easier. Replace water reservoir with lid, making sure it snaps in place.
Caution: Do not overfill water reservoir.
3.Replace empty carafe, making sure it is "seated" properly so that it fits against the lever at the back.
Important: If carafe is not placed against the safety lever at the back of the unit, your coffeemaker will not operate properly.
4.Press ON/OFF button. “ON” appears in the display and LED light above the button will illuminate as brewing begins.
5.After brewing is complete, brewed coffee will be kept warm on the “Keep Hot” carafe plate for up to 2 hours.
Note: Your coffeemaker features a
6.Once coffee grounds have cooled, carefully remove brew basket and discard paper filter with grounds. Replace brew basket.
7.Coffeemaker can be turned off at any time by pressing the ON/OFF button.
SNEAK-A-CUP® INTERRUPT FEATURE
The
Important: Carafe must be replaced in less than 20 seconds to prevent water from overflowing the brew basket.
Caution: Do not pull out brew basket when using this feature, as it is filled with hot coffee.
SETTING THE CLOCK/TIMER
You may set the clock before, during or after the brewing cycle.
To set current time: Press the HOUR, then MIN buttons until you reach the current time. Hold down buttons to advance quickly.
SETTING THE AUTO BREW FUNCTION
1.Follow steps 1 – 3 in BREWING COFFEE.
2.Make sure clock is set properly to present time (as instructed in SETTING THE CLOCK/TIMER).
3.Set
4.Press HOUR and MIN buttons until you reach your desired preset brew time.
5.After a few seconds, display will return to real time, indicating the PROG time has been set.
Note: To check preset
6.Press AUTO button; the preset program time will flash twice in the display to remind you of the time you set. The word “AUTO” will appear and the LED light above the AUTO button will illuminate; these will remain until brewing begins at preset
7.To cancel auto brew, press ON/OFF button.
COFFEE BREWING TIPS
•Always use fresh, good water when making your coffee. Since coffee is 98% water, the quality of the water is extremely important to the taste of the coffee made with it.
•Stir coffee in carafe before serving to evenly distribute the flavor.
•Coffee that is poured during brewing cycle may vary in strength from the finished brew.
•Not sure how much coffee to use? Begin by using 1 level scoop of medium grind coffee for each cup of coffee to be brewed.
•Never reuse coffee filters; they absorb flavors from the brewed coffee and will give the newly brewed coffee a stale flavor. They may also tear and allow grinds to drip into the newly brewed coffee.
•If filled carafe is left on the “Keep Hot” plate, be sure to remove the coffee grounds from the brew basket as soon as they have cooled slightly. This will keep the coffee from developing a bitter taste.
14 | 15 |