Black & Decker SDC850Q manual

12.Now, use your ruler or the paper ruler provided to measure the overhang molding height, placing your ruler vertically against the underside of the cabinet behind the overhang molding. This number determines the number of spacers you need, using a number of spacers equal to the overhang molding height. For example, a 1” overhang molding would use 2, ½” spacers on each of the rear holes (L).

L

13.Drop one of your screws through each of the washers covering the holes in the cabinet, from inside the cabinet down.

Note: To determine which screws to use, you must have enough of the screw exposed underneath the cabinet to properly thread the screw into the nut.

14.Place the appropriate number of spacers determined in step 12 on both of the rear screws so the appliance will be even (M).

M

Note: If the height of your overhang molding is too tall to be accommodated by the number of spacers provided, you may call, toll-free, at 1-800-231-9786 to order additional spacers at no charge.

Note: For spacer installation, you may require assistance (in mounting) in order to hold spacers in place while securing the appliance at the same time. If assistance is not available, use a small clamp to hold the spacers in place while you position the appliance.

Important: Top panel of coffeemaker is removable to make installation easier. Simply grip the panel at the rear and pull back to remove (see Illustration Fa) or insert a flathead screwdriver at the front of the panel by one of the mounting holes and twist to pop open (see Illustration Fb). Once removed, mount in place following the directions below and then slide coffeemaker back on the panel track to reattach appliance once the panel has been mounted.

15.Once spacers are set, hold panel up and tighten nuts onto each of the screws to secure.

Note: Always tighten nuts to ensure the appliance does not move or shake during operation.

16.Once the panel is secure, reattach coffeemaker to panel by lifting appliance up, aligning it with the track on the panel and then sliding it back into place.

17.Plug into standard electrical outlet. Extra cord can be hung over cord management hook behind unit (see Illustration G).

Caution: This appliance features a Save-A-Plug™ outlet receptacle to connect smaller †SpaceMaker™ appliances such as the mini food processor / grinder or can opener. Do not use this outlet for any other appliance!

Note: If you are connecting another †SpaceMaker™ appliance into the Save-A- Plug™ outlet, make sure you can easily unplug the appliance after each use.

18. Your †SpaceMaker™ appliance is now ready for use!

12 13