Black Box 10BASE-T/100BASE-TX G.SHDSL Two-Wire Extender/NTU System Configuration Commands, Page

•dsl show errcntr help: Lists all the commands that start with dsl show errcntr that the console recognizes.

2.6.2 System Configuration Commands

The following commands allow the user to configure the system:

•system set password <password>: Sets the system password (1-10 charac- ters).

•system set circuitid <circuitid>: Sets the circuit ID (1-64 characters).

The following commands allow the user to view the current system configuration:

•system show config: Shows the configuration of the entire system, including the DSL line.

Any changes to the system configuration or the DSL configuration will be lost on the next power cycle unless the changes are saved. The command system save config is used to save the changes.

2.6.3 System Status Commands

The following commands show system status:

•system show status: Shows the following system status information: LEDs, DSL test mode, front panel switch settings, DSL link state, and configuration mode.

2.6.4 DSL Configuration Commands

The following commands are used to configure the DSL:

•dsl set timeslots <3-89>: the equation: data-rate =

Sets the DSL data rate. (The data rate is calculated by #timeslots x 64k.

•dsl set annex <ab>: Set the annex.

•dsl set lineprobe <enableddisabled>: Enable or disable line probe.

•dsl set mode <cocpe>: Set the CPE as local (CO) or remote (CPE).

724-746-5500 blackbox.com Page 21