Black Box LB9017A-R3 manual Front Panel Display, Power, IP Reset Push Button, Port Status

Express Ethernet Switch: LB9017A-R3

Front Panel Display

The LED indicators on the front panel provide you with instant feedback on each port status, and help you monitor and troubleshoot the switch.

Figure 3: Front Panel LEDs

Power

This LED comes on when the switch is properly connected to power and turned on.

Push Button

The push button is located at the right side of port 16 on the 16-Port Switch.

Depress this button to use twisted pair port 16, and press this button to use the 100BaseFX module.

IP RESET Push Button

Press the Front panel IP RESET push button around five seconds to reset the Ethernet Switch back with the default IP Address.

Port Status

The RJ-45 ports are numbered from 1 to 16 on the 16-Port Switch.

The LEDs are located on the ports of the switch, displaying status for each respective port. Please refer to the table below for more information.

Consult the following table for details.

Before you use this table for troubleshooting, make sure the switch is properly connected to power and turned on.

Physical Ports

The 16 Ports Switch has sixteen or twenty-four 10/100Mbps ports using RJ-45 connectors and provides one slot for the optional single-port fiber module. The optional module allows fiber type (multi-mode or single-mode fiber) and connector (SC, ST, MT-RJ, VF-45, or LC) at user’s discretion.

Understanding Front Panel Design

Power LED		On	Power feeding in
		Off	Power switched off
			Improper connection
Console	LNK	On	A valid network connection
Port LED			LNK stands for LINK
		Off	No connection

7