Express Ethernet Switch: LB9017A-R3

Optional Fiber Module Installation

Consult the following illustrations before installation.

Step 1: Make sure the power is switched off. The module is not hot-swappable.

It may cause electric shock or any possible damage to the switch if the power is not switched off.

Step 2:

Step 3:

Step 4:

Step 5:

Step 6:

Step 7:

Step 8:

Remove the module from the static-free container.

Unscrew the cover plate of the expansion slot.

(The slot for single-port module is located at the right side of the switch.)

Remove the plate.

(Keep it for future use if you decide to remove this module later.)

Carefully slide the module into the slot, following the internal plastic guide rails.

Once it is fully slid in, snap in the module to make a proper connection.

Fasten the module screws.

Finally, turn on the power.

Figure 4: Removal of cover plate

Fiber module being installed

10

Page 11
Image 11
Black Box LB9017A-R3 manual Optional Fiber Module Installation, Consult the following illustrations before installation