Chapter 4: Installing the Switch
NOTES (Continued):
The SFP ports operate only at full duplex.
Ensure the network cable is NOT connected when you install or remove an SFP module.
CAUTION: Use only supported SFP modules with your switch (see Table
Figure
To install an SFP transceiver, do the following:
Step 1. Consider network and cabling requirements to select an appropriate SFP transceiver type.
Step 2. Insert the transceiver with the optical connector facing outward and the slot connector facing down. NOTE: SFP transceivers are keyed so they can only be installed in one orientation.
Step 3. Slide the SFP transceiver into the slot until it clicks into place.
NOTE: SFP transceivers are not provided in the switch package.
4.6 Connecting to an AC Power Source
You can plug or remove an AC power cord through the AC socket from the AC power source.
Figure
Step 1. Insert the AC power cord directly into the AC socket located at the front of the switch.
Step 2. Plug the other end of the power cord into an AC power source.
Step 3. Check the
Page 17 |