Black Box LMC11032A, DFCS XGT+ Stand Alone Module DFCS XGT+ Standalone Module, Page, blackbox.com

DFCS XGT+ Standalone Module

SW3 and SW4 - RESERVED

These DIP-switches are for factory use only and must always remain in the DOWN (factory default) position.

2) INSTALL STANDALONE MODULE AND CONNECT CABLES

a.The XGT+ is available as a standalone module with built-in mounting brackets. For wall-mounting, attach the XGT+ to a wall, backboard or other flat surface. For tabletop installations, place the unit on a flat level surface. Attach the rubber feet to the bottom of the XGT+ to prevent the unit from sliding. Make sure the unit is placed in a safe, dry and secure location.

To power the unit using the AC/DC adapter, connect the AC/DC adapter to an AC outlet.

Then connect the barrel plug at the end of the wire on the AC/DC adapter to the 2.5mm

DC barrel connector (center-positive) on the unit. Confirm that the unit has powered up properly by checking the power status LED located on the front of the unit.

To power the unit using a DC power source, prepare a power cable using a two conductor insulated wire (not supplied) with a 14 AWG gauge minimum. Cut the power cable to the length required. Strip approximately 3/8 of an inch of insulation from the power cable wires. Connect the power cables to the unit by fastening the stripped ends to the DC power connector.

Connect the power wires to the DC power source. The Power LED should indicate the presence of power.

WARNING: Note the wire colors used in making the positive and negative connections. Use the same color assignment for the connection at the DC power source.

NOTE: If mounting with a safety ground attachment, use the safety ground screw at the rear of the unit.

b.Insert the appropriate 10G SFP+ or XFP transceiver (depending on the model of the module) into Port 1 receptacle on the XGT+. The release latch of the transceiver must be in the closed position before insertion.

c.Connect an appropriate multimode or single-mode fiber cable to the fiber transceiver port on the XGT+. It is important to ensure that the transmit (Tx) is attached to the receive side of the device at the other end and the receive (Rx) is attached to the transmit side.

d.When using copper CX4 XFP, connect the cable between the converter and external device using the recommended copper CX4 cable.

e.Connect the RJ-45 port via a CAT 6A or better cable to a 10GBASE-T Ethernet device.

Page 6 724-746-5500 blackbox.com