DFCS XGT+ Standalone Module
This User Manual describes the functions of the DFCS XGT+ Rev 1.
Product Overview
The DFCS XGT+ is a 10 Gigabit Ethernet media converter with one 10GBASE-T RJ-45 port and one pluggable transceiver port that provides copper-to-fiber and copper-to-copper media conversion. Copper-to-fiber conversion is achieved with XFP or SFP+ fiber transceivers. Copper-to-copper conversion is achieved with a CX4 XFP transceiver.
The XGT+ supports high-power (power level 4) XFP transceivers, and the latest generation of wavelength tunable DWDM XFP transceivers.
Installation Procedure
1)Configure DIP-switches
2)Install Standalone Module and Connect Cables
3)Verify Operation
1)CONFIGURE DIP-SWITCHES DIP-SWITCH BANK 1
The location of the DIP-switches is shown in Figure 1.
The function of DIP-switch Bank is outlined in Figure 2.
Switch | DOWN | | UP |
(Default) | |
| | |
SW1 | Normal | P1 | Loopback Enabled |
| | | |
SW2 | Normal | P2 | Loopback Enabled |
| | | |
SW3 | Normal | P2 | Short Range |
| | | |
SW4 | Normal | P1 | Built-In Self Test (BIST) |
| | | |
Figure 2: DIP-switch BANK 1 Definitions
SW1 - P1 LOOPBACK “P1-LB”
When this DIP-switch is in the DOWN position (factory default), port P1 loopback is disabled. When this DIP-switch is in the UP “P1-LB” position, loopback is enabled on port P1. When enabled, all data received on port P1 is transmitted out port P1 and the connection between port P1 and port P2 is interrupted.
NOTE: For the XFP model, simultaneous loopback of port P1 and port P2 requires the XFP transceiver to support lineside loopback capability.
Page 4 | 724-746-5500 blackbox.com |
