BLADEOS 6.3 Application Guide
Using the ISCLI
1.In Privileged EXEC mode, enter the following command:
Router# copy {tftpftp}
2.Enter the hostname or IP address of the FTP or TFTP server.
Address or name of remote host: <name or IP address>
3.Enter the name of the new software file on the server.
Source file name: <filename>
The exact form of the name will vary by server. However, the file location is normally relative to the FTP or TFTP directory (usually tftpboot).
4.Enter your username and password for the server, if applicable.
User name: {<username><Enter>}
5.The system prompts you to confirm your request. Once confirmed, the software will load into the switch.
6.When loading is complete, use the following command in Global Configuration mode to select which software image (image1 or image2) you want to run in switch memory for the next reboot:
Router(config)# boot image {image1image2}
The system will then verify which image is set to be loaded at the next reset:
Next boot will use switch software image1 instead of image2.
8 | BMD00178, April 2010 |
