Blaupunkt 520 manual Security Code, Security Release Procedure, Please note, Radio PIN Code

Models: 520

1 22
Download 22 pages 32.91 Kb
Page 5
Image 5
Security Code

Security Code

Your radio includes an electronically coded security system. This security system relies on an unique PIN code to enable operation of your radio. The number only needs to be entered if the car's battery has been disconnected or if the radio has been removed from the car. Please refer to the security release procedure.

If an incorrect PIN code is entered, the radio will not operate, and there will be a time delay before the PIN code can be re-entered.

DO NOT SWITCH OFF THE RADIO DURING THE WAITING TIME.

The waiting time is approximately 10 seconds for the first 2 attempts, then 10 minutes, and up to 11 hours by the tenth attempt. The number of attempts remaining is shown in the display.

After the tenth attempt 'DEALER' appears in the display and the set is blocked. Contact your Holden Retailer to put the set back into operation.

Because the PIN code is the only means of enabling operation of the radio, we recommend that the Security Card is kept in a safe location.

DO NOT LEAVE IT IN THE GLOVEBOX OF YOUR CAR.

The PIN code should also be written down and kept with other important documents.

If your card is lost, and the PIN code is not recorded elsewhere, the PIN can be requested from your Holden Retailer, after supplying the requested ownership information. There may be a charge for this service.

Please note:

For added security a small red light on the radio blinks while the ignition is off.

Security Release Procedure

Radio PIN Code:

1.Switch on ignition.

2.Switch on the radio, if turned off.

3.The display shows 'CODE'.

4.Press and hold AS button 8, until a beep is heard and release the AS-button.

The display shows '10 _ _ _ _', which indicates that you have ten attempts left at entering the correct PIN code.

5.Enter the PIN code (see Security Card) with preset buttons 1, 2, 3 and 4.

Example:

If the PIN code belonging to the radio is 3650.

Display:

Press preset button 1 4 times 10 3 _ _ _

Press preset button 2 7 times 10 3 6 _ _

Press preset button 3 6 times 10 3 6 5 _

Press preset button 4 1 time 10 3 6 5 0

6.Press AS button 8 until a beep is heard and the radio starts operating.

If a wrong PIN code has been entered the display will show '9 SAFE'. After the waiting time '9 _ _ _ _' will be shown on the display indicating that there are nine attempts left. The correct code should now be entered.

1

Page 5
Image 5
Blaupunkt 520 manual Security Code, Security Release Procedure, Do Not Leave It In The Glovebox Of Your Car, Please note