TONE AND VOLUME
Tone and volume
Note:
You can make separate adjustments to the bass, treble and loudness for each audio source.
Adjusting the bass
➮Press the AUD button, 9. “BASS” appears in the display.
➮Press the
or
buttons, 7, in order to adjust the bass.
When you have finished the adjustment
➮Press the AUD button, 9.
Adjusting the treble
➮Press the AUD button, 9. “BASS” appears in the display.
➮Press the 
or 
button, 7, as often as is necessary for “TREBLE” to appear in the display.
➮Press the
or
buttons, 7, in order to adjust the treble.
When you have finished the adjustment
➮Press the AUD button, 9.
Loudness
Loudness refers to a bass boost at low vol- ume levels matching the ear’s sensitivity.
➮Press the AUD button, 9. “BASS” appears in the display.
➮Press the 
or 
button, 7, as often as is necessary for “LOUD” to appear in the display.
➮Press the
or
buttons, 7, in order to adjust the loudness. “LOUD OFF” means that the loudness function is in- active, while “LOUD 6” indicates the maximum loudness boost.
When you have finished the adjustment
➮Press the AUD button, 9.
Adjusting the left/right volume balance
➮In order to adjust the balance, press the AUD button, 9.
“BASS” appears in the display.
➮Press the 
or 
button, 7, as often as is necessary for “BAL” to appear in the display.
➮Press the
or
buttons, 7, in order to adjust the balance between left and right.
When you have finished the adjustment
➮Press the AUD button, 9.
Adjusting the front/rear volume ratio (fader)
➮In order to adjust the fader, press the AUD button, 9.
“BASS” appears in the display.
➮Press the 
or 
button, 7, as often as is necessary for “FADER” to appear in the display.
➮Press the
or
buttons, 7, in order to adjust the balance between front and rear.
When you have finished the adjustment
➮Press the AUD button, 9.
TA-SOUND
You can make separate adjustments to the tone and volume for traffic announcements.
➮Hold down the softkey, 4, indicating “TA” for longer than two seconds.
➮Press the 
or 
button, 7, as often as is necessary for the desired parame-
ter to appear in the display.
➮Perform the adjustments using the
or
key, 7.
When you have finished the adjustment
➮Press the AUD button, 9.
38
