Handling the Remote Control Unit
ENGLISH
ÇAIS
Removing the battery insulation sheet
If an insulation sheet is attached to the remote control unit, make sure to remove the insulation sheet before use. In this case, the batteries will already be inside and can be used immediately.
Insulation Sheet
Operation
Operate while facing towards the sensor of the main unit.
Switching the Source 
The mode will switch each time the SRC button is pressed.
Radio
CD 
CDC or AUX
Direct Access 
For direct access during radio mode or CDC mode, use the following operations.
Precautions on battery use
Always use lithium batteries (CR2025).
Warning
Use the lithium batteries properly
(1)Never recharge, short circuit, disassemble, modify, heat or place in fire. This may result in fire, generation of heat or explosion.
(2)Place batteries out of reach of infants. If accidentally swal- lowed, consult a physician immediately.
(3)Use tape to insulate whenever disposing or storing batter- ies. Contact with metals or other batteries may result in fire or explosion.
FRAN
Inserting Batteries
1. Push A in the direction of the arrow while holding B and pull out.
2. Confirm that the (+)
➜ | or | ➜ |
hold for | , |
|
2 seconds |
| |
(Direct access mode) | (select) | (set) |
Caution
Properly align the battery (+) (-) terminals
• Improper handling of batteries may cause fluid leakage or |
explosions and may result in damage to the device or in- |
jury. |
Align the battery (+) |
PORTUGUÊS ESPAÑOL
3. Push in the battery case until a “click” can be heard. | Radio mode | CD mode | CDC mode | Aux | |
Remote control | Lithium battery | Seek tuning |
| Scan play |
|
(CR2025) | Scan play |
| |||
unit rear surface | Preset scan** | Disc scan** |
| ||
|
|
| |||
|
|
| Volume up/down |
| |
|
|
| cue* | Disc up |
|
| B | Seek tuning |
|
|
|
|
| Review* | Disc down |
| |
|
|
|
| ||
Battery case |
| Preset select | Track search | Track search |
|
| A | Band select | Cue/Review* |
| |
| Treble store** |
|
|
| |
|
|
|
|
| |
* Press and hold
** Press and hold for 2 seconds
• Do not leave the remote control unit in high temperature |
such as from direct sunlight. It results in the deformation of |
the case, leakage of battery acid, and so on. |
