Connections
Caution
•Connect each pair of speaker leads only to a single speaker (or speaker system) that has an impedance of least 4 ohms, as well as 42 watts
•Do not connect speaker leads to any inputs on external amplifiers. This will cause damage to the internal amplifier of this unit.
Connection procedure
Warning
•To prevent short circuit, remove the key from the ignition and disconnect the battery’s
•This unit is designed for negative ground 12 V DC operation only. You can not use it for 24 V or other types of car batter- ies.
1Make sure the car’s ignition key has been removed.
2Disconnect the minus terminal of the car’s battery.
3Connect the wiring harness wires in the following order : GND (Black), BTT (Yellow), ACC (Red) and ANTENNA REMOTE (Blue), and tape each so they do not come in contact with each other.
4Connect the speaker wires of the wiring harness.
5Connect the car’s antenna terminal to the antenna socket of the unit.
6Connect the detachable wire harness to the unit.
7Reconnect the minus terminal of the car’s battery.
8Start the car’s engine.
9Make sure the unit operates properly.
Connection Example
FUSE (10A)
ADDITIONAL
SPEAKERSDETACHABLE EXTERNAL WIRE HARNESS AMPLIFIER
REMOTE
(IF ANY)
BLUE
LEFT FRONT
SPEAKERANTENNA REMOTE
(IF ANY)
WHITE W/BLACK STRIPE
WHITE | GREEN W/BLACK STRIPE |
| |
| GREEN |
LEFT REAR | |
SPEAKER |
|
REAR OF UNIT | |||
|
|
| OUTPUTS |
|
|
| |
ANTENNA
SOCKET
YELLOWBATTERY (CONSTANT POWER)
RED |
|
| RIGHT FRONT |
|
|
| |
|
|
| SPEAKER |
| IGNITION SWITCH | ||
BLACK
GROUND
GRAY
GRAY W/BLACK STRIPE | VIOLET |
| |
VIOLET W/BLACK STRIPE | |
| RIGHT REAR |
| SPEAKER |
