Warning beep
If you leave the reception area of the traffic programme station currently tuned into, you will hear a warning beep after approximate- ly 30 seconds.
This alarm tone will also be released when pressing a preset button which has no traf- fic programme allocated to it.
Switching the warning beep off
a) Tune into another station offering traf- |
fic information: |
Automatic seek tuning start
(CD and CDC operation)
When leaving the reception area of the tuned in traffic programme station while listening to a CD, the system will automatically start searching for a new TA programme.
If no such station is found within approxi- mately 30 seconds, CD operation will be stopped and a warning beep will sound. To switch the warning beep off, proceed as described above.
To make a setting:
•During an announcement, adjust the balance and fader C settings to suit your personal preferences.
• | Press the rocker switch or |
• | press a preset button which has a |
| traffic programme station allocated |
| to it. |
Alternatively:
b)Switch off the priority for traffic an- nouncements:
•Press TIM for approximately two seconds until you hear a beep. “TA” will disappear from the dis- play.
Adjusting the volume for traffic announcements and the warning beep
This volume was preset at the factory, though you can alter the value using the DSC function (see “DSC programming, TA VOL”).
Adjusting GEO for traffic mes- sages and the warning beep
You can separately adjust the balance and fader settings for both traffic announcements and the warning beep.
For example, it is possible to listen to traffic reports via the front left (right) speaker only. This provides the driver with the important traffic information without bothering the rear passengers too much.
48
