en | en |
Transport instructions
The device should be transported only in upright position.
The packing as supplied must be intact during transportation.
If refrigerator has been transported or carried in the horizontal position, the refrigerator may only be plugged in after being in the vertical position for 4 hours. Plugging in the refrigerator any sooner may result in damage to the refrigerator and affect your warranty.
Disposal
Make the device unusable immediately. Pull out the mains plug and cut the power cable. Remove or destroy snap or latch locks before disposing of the device. In this manner you prevent children from locking themselves in and endangering their lives.
Appliance setup
•Do not operate your appliance in a room where the temperature is likely to fall below 10 °C at night and/or especially in winter. At lower temperatures the appliance may not operate, resulting in a reduction in the storage life of the food.
•The climate class rate of your appliance is given on the rating label located inside the appliance. It specifies the appropriate operating ambient temperatures as explained below.
Climatic class | Ambient temperatures |
SN | +10 °C to 32 °C |
N | +16 °C to 32 °C |
ST | +18 °C to 38 °C |
T | +18 °C to 43 °C |
+10 °C to 38 °C | |
+10 °C to 43 °C |
Location
Only place the device in dry rooms which can be aired.
Avoid direct sunlight or direct heat sources such as a stove or a heater.
If this cannot be avoided, the following minimum distances should be maintained: Electric stoves: 3,00 cm
Heater: 3,00 cm
Cooling devices: 2,50 cm
•Ensure sufficient air circulation for your device.
•Make sure that sufficient room is provided around the appliance to ensure free air circulation.
Fit the two plastic wall spacers supplied with the appliance rotating 1/4 turn to the condenser at the back of the appliance.
1
2
1
2