Blomberg DV16540NBL00 Adjusting the feet, Ventilation duct and connection

when they are full. Therefore, the floor must be capable of carrying the load placed on it!

Adjusting the feet

In order to ensure that your appliance operates more silently and vibration-free, it must stand level and balanced on its feet. The

front feet of the appliance can be adjusted. Balance

the appliance by adjusting the feet.

1. Loosen the feet by hand.

2. Adjust them until the appliance stands level and firmly.

C Do not use any tools to loosen the adjustable feet. Otherwise, they may be damaged.

C Never unscrew the adjustable feet from their housings.

2 plastic pieces supplied together with the Operating Instructions prevent your appliance from slipping on wet and slippery surfaces. To install these plastic parts:

1.Tilt the appliance backwards.

2.Fit the plastic parts to the front adjustable feet. Press on the plastic parts to fix them in their places.

3.Check the balance of the appliance again and readjust the adjustable feet if necessary.

Ventilation duct and connection

Ventilation duct ensures exhaust of air from inside the appliance.

The vented dryer has 1 air outlet.

AOnly rigid or flexible metal duct should be used for exhausting, unless the appliance has been checked for use with nonmetallic duct or the duct has been checked and found acceptable for use with clothes dryers.

The diameter of the duct to be used should be 4” (102 mm).

Maximum duct length is given in the table below:

Metal rigid duct

Maximum length 21 ft (6.5 m) + 2 elbows

To connect a ventilation duct;

1.Connect the air outlet metal duct to the spacer by turning it counter-clockwise.

2.Make the duct passages as shown the picture below.

C Exhaust of humid air from the dryer into the room is to be avoided. It may damage the walls and furniture in the room.

C The ventilation duct can be routed outdoors via a window or it can be connected to the air outlet in a bathroom.

C Air outlet duct must be extended directly outdoors. There must be a limited number of elbows to not hinder air flow.

C To prevent water accumulation in the duct, make sure it is not folded on the floor.

A The appliance should not be vented into a chimney, a wall, a ceiling, or a concealed space of a building.

A Do not operate the appliance at the same time with heaters such as a coal or gas stove. Airflow may cause the chimney to flare up.

C Care must be taken not to pinch or bend the ducts.

C The end of the hose should not be bent, it should not be stepped on and it must not be folded between the drain and the machine.

C The duct shall not be assembled with screws or other fastening means that extend inside the duct to catch lint.

11 - EN