Blomberg IWD 1005 XT Electric connection, Disposing of the packaging, Placing and Installation

Models: IWD 1004 ET IWD 1004 XT IWD 1005 XT KWD 9330 X A+ KWD 9440 X A+ KWD 9440 X KWD 9440 XA++

1 38
Download 38 pages 22.99 Kb
Page 11
Image 11

4.Plug the refrigerator into the wall outlet. When the door is open the respective interior light will come on.

5.You will hear a noise as the compressor starts up. The liquid and gases sealed within the refrigeration system may also give rise to noise, even if the compressor is not running and this is quite normal.

6.Front edges of the refrigerator may feel warm. This is normal. These areas are designed to be warm to avoid condensation.

Electric connection

Connect your refrigerator to a grounded socket which is being protected by a fuse with the appropriate capacity.

Important:

B The connection must be in compliance with national regulations.

B The power cable plug must be easily accessible after installation.

B The specified voltage must be equal to your mains voltage.

B Extension cables and multiway plugs

must not be used for connection.

B A damaged power cable must be replaced by a qualified electrician.

B The appliance must not be operated before it is repaired! There is danger of electric shock!

Disposing of the packaging

AThe packing materials may be dangerous for children. Keep the

packing materials out of the reach of children or dispose them of by classifying them in accordance with the waste instructions. Do not dispose them of along with the normal household waste.

The packing of your refrigerator is produced from recyclable materials.

Disposing of your old refrigerator

Dispose of your old machine without giving any harm to the environment.

A You may consult your authorized dealer or waste collection center of your municipality about the disposal of your refrigerator.

A Before disposing of your refrigerator, cut out the electric plug and, if there are any locks on the door, make them inoperable in order to protect children against any danger.

Placing and Installation

B Caution: Never plug the refrigerator into the wall outlet during installation. Otherwise, risk of death or serious injury may arise.

A If the entrance door of the room where the refrigerator will be installed is not wide enough for the refrigerator to pass through, than call the authorised service to have them remove the doors of your refrigerator and pass it sideways through the door.

1.Install your refrigerator to a place that allows ease of use.

2.Keep your refrigerator away from heat sources, humid places and direct sunlight.

3.There must be appropriate air ventilation around your refrigerator in order to achieve an efficient operation. If the refrigerator is to be placed in a recess in the wall, there must be at least

5cm distance with the ceiling and at

10

EN

Page 11
Image 11
Blomberg IWD 1005 XT, KWD 9440 XA++ Electric connection, Disposing of the packaging, Disposing of your old refrigerator