![](/images/new-backgrounds/1135294/13529431x1.webp)
detected by sensors during a drying cycle and the remaining time is updated automatically.
Canceling the time delay
If you want to cancel the time delay countdown and start the program:
1.Press the “Start/Pause/Cancel” button for about 4 seconds. The “:” in the middle of the screen will stop flashing. The “Start/Pause/Cancel” light will go off and the remaining time on the screen disappears.
2.Press the "Start/Pause/Cancel" button to start the program right away.
Starting the Program
1.Press the "Start/Pause/Cancel" button to start the program.
2.The “Start/Pause/Cancel” button will light up to indicate that the program has started.
Progress of program
Progress of a running program is shown through the program
"Drying":
-Drying level will be illuminated during the whole drying process until the drying degree reaches "iron dry".
"Iron Dry":
-Starts to illuminate when the drying degree reaches "iron dry" step and remains illuminated until the next step.
"Cupboard Dry":
-Starts to illuminate when the drying degree reaches "Cupboard dry" step and remains illuminated until the next step.
“Cooling”:
-It lights up during the
phase at the end of drying.
“Final / Anti-creasing”:
-Illuminates when the program comes to an end and
Important:
If more than one LED light up or flash concurrently, it means there is malfunctioning or a failure (please see, Solution suggestions for problems).
Changing the program after the program has started
You can use this feature after your machine has started to dry your clothes under higher or lower temperatures.
For example;
Press and hold the “Start/Pause/Cancel” button for about 4 seconds to “Cancel” the program in order to select “Extra Dry” program instead of “Iron Ready” program. Select the “Extra Dry” program by rotating the program knob.
Press the "Start/Pause/Cancel" button to start the program.
CThe program which is selected first will go on even if the program selection button is moved and another program mode is selected while the machine is operating. You must cancel the ongoing program in order to change the drying program. (See, Ending the program through canceling)
Adding/removing laundry in standby mode
In order to add or take out laundry after the
1. Press the “Start/Pause/Cancel” button to switch the machine to “Pause” mode. Drying process will stop.
2. Open the door at Stop position and close it again after adding or taking out laundry.
3. Press "Start/Pause/Cancel" button to start the program.
C Any laundry added after the drying process was started may cause the already dried clothes in the machine intermingle with wet clothes and the
15 - EN