Blomberg TKF 7330 A Solution suggestions for problems, Problem Cause Explanation / Suggestion

7Solution suggestions for problems

Problem	Cause	Explanation / Suggestion
Drying process	Cover filter and filter drawer might
takes too much		* Clean the cover filter and Filter drawer.
	have not been cleaned.
time.
Laundry come	* Cover filter and filter drawer might
	have not been cleaned.	* Clean the cover filter and Filter drawer.
out wet at the
	* Excessive laundry might have been	* Do not overload the machine.
end of drying.
	loaded in.
Machine does	* It might have not been plugged in.	* Make sure that the machine is plugged in.
not switch on	* The loading door may be ajar.
		* Make sure that the loading door is properly
or the program	* Program might have not been set
		closed.
does not start.	or the "Start/Pause/Cancel" button
		* Make sure that the program has been set and it
Machine is not	might have not been pressed.
		is not in “Stop” mode.
activated when	* "Childproof lock" might have been
		* Deactivate the childproof lock.
set.	activated.
Program has		* Make sure that the loading door is properly
been interrupted	* The loading door may be ajar.	closed.
without any	* Electricity may be cut off.	* Press the "Start/Pause/Cancel" button to start
cause.		the program.
Laundry has		* Dry only the laundry which is suitable for drying
		in your machine after checking the labels on your
shrunk, become	* A program suitable for the laundry
		clothes.
felted or	type might have not been used.
		* Select a program with suitable temperature for
deteriorated.
		the laundry type to dry your clothes.
Drum lightning
does not come	* The machine might have not been
on.		* Make sure that the machine is On.
	started by using the On/Off button.
(for models		* Call the authorized service to replace the bulb.
	* Bulb may have blown.
equipped with a
lamp)
“Final / Anti-	* The 2-hour anti creasing program
creasing” light	to prevent laundry from creasing	* Turn off the machine and take out the laundry.
flashes.	might have been activated.
“Final / Anti-
creasing” light	* Program has come to an end.	* Turn off the machine and take out the laundry.
is on.
The “Drying” light	* A heat sensor failure has occurred.	* Turn off the machine and take out the laundry.
	Machine ends the program without
flashes.	heating.	Call your authorized service.
Also, for products equipped with a “Condenser” and a “Heat pump”
“Tank full”	* Water may be full.
warning light is	* Anti-creasing program might be	* Drain the water in the water tank.
on.	running.
“Filter cleaning”	* Filter might have not been cleaned.	* Clean the cover filter.
light is on.
“Condenser	* Filter drawer/Condenser might	* Clean the filters in the condenser/filter drawer
cleaning” light
	have not been cleaned.	under the kick plate.
is on.

A Call an authorized service if the problem persists.

20 - EN