Blomberg TKF 7330 A manual Condenser sponge for products equipped with a heat pump

Models: TKF 7330 A

1 44
Download 44 pages 16.16 Kb
Page 19
Image 19

phase is the filter sponge in the filter drawer. To clean the filter drawer;

1Pull out the filter drawer.

2Clean lint, fibre, and cotton raveling by hand or with a soft piece of cloth.

3Open the filter drawer by pressing the red button.

4Take out the filter drawer sponge.

5If the sponge is covered with lint and fibers, it must be cleaned. Wash the sponge by hand to clean it and squeeze to drain excessive water. After washing the sponge, any remaining lint particles among the

pores is not important.

CIf the lint and fibres collected in the drawer is sparse and small, you do not have to clean the sponge.

6Place the sponge back into its place.

7 Close the filter unit as to lock the red button.

8.Place the filter drawer back into its place and push forward until a click sound is heard.

Important:

Drying without the filter sponge will damage your machine!

A dirty heat pump will cause longer drying periods and higher energy consumption.

Place the sponge as shown below, without forcing it. Pay attention to

seat the left side of the sponge into the appropriate housing in the filter drawer as marked in the picture.

Do not squeeze the sponge to make it go into the inner frame as shown in the picture below.

Condenser sponge (for products equipped with a heat pump)

It is very important that the lint and fibres are caught completely by the filters of your machine which is equipped with

a condenser with heat pump. Failure in functioning of the filters may cause a drop in the performance or breakdown of your machine. Therefore, in addition to the “Cover Filter” and “Filter Drawer” filtering phases in your machine, there is also a “Condenser Sponge” piece for protection purpose. If the “Cover Filter” and “Filter Drawer” are functioning appropriately, , “the “Condenser Sponge” piece should be checked every 3 months. Any layer of accumulated lint on the sponge must be

removed.

CIf the lint and fibre collected on the sponge is sparse and small, you do not have to clean the sponge.

To clean the condenser sponge;

1Take out the condenser sponge from

C its place.You can reach the condenser filter

after taking out the filter drawer.

18 - EN

Page 19
Image 19
Blomberg TKF 7330 A manual Condenser sponge for products equipped with a heat pump