8Suggested solutions for problems
Drying process takes too much time
• Meshes of the filter may be clogged. Wash with water.
Laundry comes out wet at the end of drying.
•Meshes of the filter may be clogged. Wash with water.
•Excessive laundry might have been loaded in. Do not load the dryer in excess.
Dryer does not switch on or the programme does not start. Dryer is not activated when set.
•It might have not been plugged in. Make sure that the machine is plugged in.
•The loading door may be ajar. Make sure that the loading door is properly closed.
•Programme might have not been set or the "Start/Pause/Cancel" button might have not been pressed. Make sure that the programme has been set and it is not in “Pause” mode.
•"Childproof lock" might have been activated. Deactivate the childproof lock. Programme has been interrupted without any cause.
•The loading door may be ajar. Make sure that the loading door is properly closed.
•Electricity may be cut off. Press "Start/Pause/Cancel" button to start the programme.
Laundry has shrunk, become pilled or deteriorated.
•A programme suitable for the laundry type might have not been used. Dry only the laundry which is suitable for drying in dryer after checking the labels on your clothes.
•Select a programme with suitable low temperature for the laundry type to dry your clothes.
Drum lightning does not come on.
•Dryer might have not been started by using the "On/Off" button. Make sure that the dryer is on.
•Bulb may have blown. Call the authorized service to replace the bulb.
“Final /
•The
“Final /
•Programme has come to an end. Turn off the dryer and take out the laundry. For products with a condenser:
“Water tank” warning symbol is on.
•Water may be full.
•
•Filter might have not been cleaned. Clean the cover filter.
“Condenser cleaning” symbol is on.
•Filter drawer/Condenser might have not been cleaned. Clean the filters in the condenser/filter drawer under the kick plate.
ACall an authorised service if the problem persists.
25
EN
