You can directly send the accumulated water out through the water drain hose supplied with the machine instead of periodically draining the water collected in the water tank.
Please refer to the detailed instructions supplied with the accessories pack.
Connecting the water drain hose;
1.Remove the hose on the machine by pulling it out from its end. Do not use any tools to take out the hose.
2.Connect the special drain hose supplied with the machine to the pipe fitting.
3.The other end of the drain hose can be directly connected to the wastewater drain or to the washbasin. The fitting must always be secured in all types of connections. Your house may be flooded if the hose gets out of its housing during water discharge.
Important:
•The hose should be attached to a height of maximum 100 cm.
•You must be careful not the pinch or bend the hose.
•The end of the hose should not be bent, it should not be stepped on and it must not be
folded between the drain and the machine.
Adjusting the feet
In order to ensure that your machine operates more silently and
Rotate the feet to adjust until the machine stands level and firmly.
CNever unscrew the adjustable feet from their housings.
Electrical connection
Connect the machine to a grounded outlet protected by a fuse of suitable capacity as stated in the technical specifications table. Our company shall not be liable for any damages that will arise when the machine is used on a circuit without grounding.
•Connection must comply with national regulations.
•If the current value of the fuse or breaker in the house is less than 16 Amps, have a qualified electrician install a 16 Amp fuse.
•Power cable plug must be within easy reach after installation.
•The voltage and allowed fuse or breaker protection are specified in the “Technical Specifications” section.
•The specified voltage must be equal to your mains voltage.
•Do not make connections via extension cables or
•The main fuse and switches must have a contact distance of minimum 3 mm.
B Damaged power cable must only be replaced by a qualified electrician.
B If the product is faulty, it must not be operated unless it is repaired! There is the risk of electric shock!
First use
•To have the product ready for operation before calling the authorised service agent, make sure that its location and power supply installations are appropriate. If they are not, call a qualified electrician to have any necessary arrangements carried out.
•Make sure that the power connections of the product are in accordance with the instructions given in relevant chapters of this manual.
6 EN
