packaging reinforcement.
ARemove the transportation safety bolts before operating the washing machine, otherwise, the product will be damaged.
1.Loosen all the bolts with a spanner until they rotate freely (C).
2.Remove transportation safety bolts by turning them gently.
3.Attach the plastic covers supplied in the User Manual bag into the holes on the rear panel. (P)
CKeep the transportation safety bolts in a safe place to reuse when the washing machine needs to be moved again in the future.
CNever move the product without the transportation safety bolts properly fixed in place!
Connecting water supply
CThe water supply pressure required to run the product is between 1 to 10 bars (0.1 – 10 MPa). It is necessary to have 10 – 80 liters of
water flowing from the fully open tap in one minute to have your machine run smoothly. Attach a pressure reducing valve if water pressure is higher.
CIf you are going to use the double
(Applies for the products supplied with a blind stopper group.)
CIf you want to use both water inlets of the product, connect the hot water hose after removing the stopper and gasket group from the hot water valve. (Applies for the products supplied with a blind stopper group.)
AModels with a single water inlet should not be connected to the hot water tap. In such a case the laundry will get damaged or the product will switch to protection mode and will not operate.
ADo not use old or used water inlet hoses on the new product. It may cause stains on your laundry.
1.Connect the special hoses supplied with the product to the water inlets on the product. Red hose (left) (max.
90 ºC) is for hot water inlet, blue hose (right) (max. 25 ºC) is for cold water inlet.
38EN
