Bloomfield 8740 INSTALLATION continued, Shock Hazard, Electrician’S Installation Instructions

Models: 8740

1 22
Download 22 pages 18.93 Kb
Page 7
Image 7
ELECTRICIAN’S INSTALLATION INSTRUCTIONS

608 p/n 76467 8740 Tea Brewer Owners Manual

ELECTRICIAN’S INSTALLATION INSTRUCTIONS

REFER TO ELECTRICAL SPECIFICATIONS - Page 1 Check the nameplate to determine correct electrical service required for the Brewer to be installed.

IMPORTANT: Before connecting to electricity, make sure automatic brewers are connected to the water supply.

Model 8740 is equipped with a cord and plug.

It requires a 115 - 125 volt 20 amp circuit (50/60 Hz, 2 wire plus ground, with NEMA 5-15R receptacle).

PREPARATION

The water tank must be filler prior to operation. Slide an empty brew chamber in place under the brew head. Place an empty dispenser under the brew chamber.

Be sure the unit is connected to the water supply, the water supply is turned ON and the "TANK HEATER SWITCH" is OFF. Connect the unit to electric power.

Press the "START BREW" switch to initiate a brew cycle. The solenoid will open and begin filling the tank. Initiate consecutive brew cycles until water begins to flow from the brew head.

When all water stops dripping, discard all water generated. Press the "TANK HEATER SWITCH" to ON. The heating elements will begin heating the water in the tank. When the "READY TO BREW" light glows the unit is ready for use.

INSTALLATION (continued)

WARNING

SHOCK HAZARD

Brewer must be properly grounded to prevent possible shock hazard. DO NOT assume a plumbing line will provide such a ground. Electrical shock will cause death or serious injury.

IMPORTANT:

Supply power must match nameplate for voltage and phase. Connecting to the wrong voltage will damage the brewer or result in decreased performance.

Such damage is not covered by warranty.

GROUND

PIN

NEMA 5-15P

NEMA 5-15R

PLUG

RECEPTACLE

Fig. 3 Plug Configuration

IMPORTANT: The ground prong of the plug is part of a system designed to protect you from electrical shock in the event of internal damage. Never cut off the ground prong nor twist a blade to fit an existing receptacle. Contact a licensed electrician to install the proper circuit and receptacle.

IMPORTANT: Do not connect brewer to electrical power until you are ready to fill the tank.

See instructions at left.

5

Page 7
Image 7
Bloomfield 8740 owner manual INSTALLATION continued, Shock Hazard, Electrician’S Installation Instructions, Preparation