Bloomfield G-24 INSTALLATION continued, Electrical Shock Hazard, Risk Of Damage, Equipment Setup

INSTALLATION (continued)

WARNING: ELECTRIC SHOCK HAZARD

All servicing requiring access to non-insulated electrical components must be performed by a factory authorized technician.

DO NOT open any access panel which requires the use of tools. Failure to follow this warning can result in severe electrical shock.

101 p/n 303339 OpManual Countertop Electric Griddles

ELECTRICAL INSTALLATION

Refer to the nameplate. Verify the electrical service power. Voltage and phase must match the nameplate specifications. Connecting the griddle to the wrong voltage can severely damage the unit or cause noticeably decreased performance.

IMPORTANT: Damage due to being connected to the wrong voltage is NOT covered by warranty.

Use copper wire suitable for at least 90ºC for supply connections.

Griddles are factory wired three-phase (3ø).

For single-phase (1ø) wiring, refer to the wiring diagram attached to the griddle.

This griddle is not fused. Protect the circuit with properly sized fuses or circuit breaker.

An electrical disconnect must be installed readily accessible to the operator of the griddle.

EQUIPMENT SETUP

Install splashguard. Notches on front wings lock into exposed studs in grease trough.

Slide grease drawer into grease drawer sleeve in front of griddle.

CAUTION:

RISK OF

DAMAGE

DO NOT connect or energize this appliance until all installation instructions are read and followed. Damage to the appliance will result if these instructions are not followed.

CAUTION:

ELECTRICAL SHOCK HAZARD

This griddle must be electrically grounded. Connect the terminal marked “GND” or “ ”

to a suitable building ground.

IMPORTANT: Damage due to being connected to the wrong voltage or phase is NOT covered by warranty.

5