Bloomfield WVAE-30F operation manual Troubleshooting Suggestions

TROUBLESHOOTING SUGGESTIONS

PROBLEM	POSSIBLE CAUSE	SUGGESTED REMEDY
Unit will not operate	Disconnected from electric power	Reconnect to electric power
(no indicators lights lit)		Reset circuit breaker for unit
Unit will not operate	Fire suppression system not set	Contact an authorized Ansul® distributor for repairs
(buzzer sounds)
CHECK FILTER light lit	HEPA air filter or grease baffle not in position	Properly install HEPA filter and grease baffle
REPLACE FILTERS light lit	HEPA air filter and charcoal filters nearing	Arrange to replace both HEPA and charcoal filters in
	end of service life	a timely manner
SERVICE REQUIRED light lit	HEPA air filter and charcoal filters plugged	Replace both HEPA and charcoal filters
(fryer not operating)
	Fire damper in exhaust collar has closed	Contact an authorized Wells service agent for
		repairs
	One or more vacuum sensing lines or ports	Contact an authorized Wells service agent for
	plugged	repairs
	NOTE: If, after 10 seconds, there is insufficient airflow for proper operation, SERVICE REQUIRED
	light will illuminate and fryer will be de-energized.
	Press FRYER POWER SWITCH to OFF, then back to FRYER to reset system.
		NOTE:
		FILTERS are the only user serviceable components
		in this ventilator hood system. For all problems that
		cannot be remedied by servicing the filters, contact:
		Fryer or ventilator section - authorized Wells
		service agency
		Fire suppression system - authorized Ansul®
		distributor

IMPORTANT:

Contact ANSUL® for fire suppression system installation, set-up and service:

Ansul Incorporated	1-800-TO-ANSUL (1-800-862-6785)
One Station Street
Marinette, WI 54143-2542	website http;//www.ansul.com

IMPORTANT:

Parts used in the Ansul® fire suppression system are not serviceable by the owner/operator. Procedures for servicing fire suppression equipment are described in:

ANSUL® R-102 SYSTEM DESIGN, INSTALLATION, RECHARGE AND MAINTENANCE MANUAL (418087, current edition)

NOTE:

ANSUL® Manual 41807 and Wells Bulletin 301646 are intended for use by authorized Ansul® service personnel only.

M381 301603 OpM (Supplemental) NFPA Hood

18