Contact 1.800.762.1142 for assistance.

Do not return to place of purchase.

Step 5–Center Lockup

Slide the threaded portion of the large thumbscrew through the slot in the center of the bracket mounted to the base..

Thread the bottom bracket on to the thumbscrew with the round flat rubber pads facing up..

To mount the heater to a hole in your table, tilt the bottom bracket/ thumbscrew assembly until it fits through the hole.. Straighten the thumbscrew, and pull it up until the rubber pads contact the underside of the table.. Hand tighten only..

Note: If the hole in the surface you are mounting your heater to is less than 1-1/2” in diameter, it will be necessary to center your heater over the hole and slide the thumbscrew through the slot in the bracket and the hole in the table.. Attach the bottom bracket from underneath, and tighten from the top with the thumbscrew..

Notice

Do not use tools to tighten the thumbscrew. Hand tighten only. Do not over tighten to prevent possible damage to table surface.

Step 6 – Gas Hook-up

Note: For best results, use heater with a 20 lb.. cylinder..

The pressure regulator and hose assembly supplied with the appliance must be used and replacements must be those specified by the manufacturer..

To connect 20 lb. Cylinder

Slip end of flexible gas line with brass fitting through center hole of Base and up to threaded portion of regulator..

Line up threads on fitting with those on regulator and rotate clockwise until snug.. HAND TIGHTEN ONLY.. DO NOT USE ANY HAND TOOLS TO MAKE THIS CONNECTION.. Be careful not to cross threads when screwing in FITTING..

Note: if heater uses center clamp, hose can be routed through opening in base and table..

Set heater on base, making sure that flexible gas line is routed through small slot in base..

Attach gas line to cylinder by turning black plastic knob counter clockwise into cylinder valve until tight..

Note: Be careful not to kink flexible gas line..

When using the gas extension hose always locate the hose out of pathways where people may trip over it or in areas where the hose may be subject to accidental damage..

To connect 14.1 oz or 16.4 oz cylinder

Only cylinders marked “propane” may be used..

Note: Some 1-lb cylinders may form frost when near empty..

Line up threads on canister with those on regulator, insert and rotate canister clockwise until they fit snugly together.. HAND TIGHTEN ONLY.. Be careful not to cross threads when screwing in canister..

Caution

Before you attempt to use a propane cylinder, understand all cylinder and propane related precautions in Section #1 – “Safety First.”

Owner’s manual: model 82300C portable outdoor heater