
Contact |
| ® | ||
Do not return to place of purchase. |
|
| ||
|
|
|
| |
|
|
|
| |
Troubleshooting |
|
|
| |
|
|
| ||
If the problem is: | And this condition exists: | Then do this | ||
Burner won’t light | Gas pressure is low | Replace bottle/cylinder or canister | ||
|
|
| ||
| Blockage in burner openings | Clear blockage | ||
|
|
| ||
| Blockage in venturi tube | Clean venturi | ||
|
|
| ||
| Blockage in gas line | Check gas line for blockage | ||
|
|
| ||
| Control knob is not in ON position | Turn control knob to ON | ||
|
|
| ||
Burner won’t stay lit | Bad thermocouple | Replace ODS | ||
|
|
| ||
| Corrosion at thermocouple | Clean contact | ||
|
|
| ||
| Burner flame not touching | Contact certified technican | ||
| thermocouple |
| ||
|
|
| ||
Burner flame is low | Gas pressure is low | Turn Control Knob OFF and replace | ||
|
|
| bottle/cylinder or canister | |
|
|
| ||
| Outdoor temperature is less than 40ºF | Use a full bottle/cylinder or canister | ||
Note: Heater operates at reduced | and tank is less than 1/4 full |
| ||
efficiency below 40ºF (5ºC) |
|
|
| |
Control knob fully ON | Check burner and all openings for | |||
| ||||
|
|
| blockage | |
|
|
| ||
Emitter glows uneven | Gas pressure is low | Replace bottle/cylinder or canister | ||
|
|
| ||
| Heater not level | Level heater | ||
|
|
| ||
| Burner tilted | Straighten burner | ||
|
|
| ||
Carbon | Base is not on a level surface | Place heater on a level surface | ||
|
|
| ||
| Heater is level | Clean burner | ||
| Dirt or film on reflector and emitter | Clean reflector and emitter | ||
|
|
| ||
Thick black smoke | Blockage in burner | Remove blockage and clean burner | ||
|
|
| inside and outside | |
|
|
|
|
Owner’s manual: model 92000 portable outdoor heater | 12/3/03 | 14 |