| page no. |
Contact 1.800.762.1142 for assistance. Do not return to place of purchase. | 15 |
| |
|
|
Cleaning and Care
CAUTION:
1.All cleaning and maintenance should be done when grill is cool and with the fuel supply disconnected.
2.DO NOT clean any grill part in a self cleaning oven. The extreme heat will damage the finish.
3.Do not enlarge valve orifices or burner ports when cleaning the valves or burners.
Notices
1.This grill should be thoroughly cleaned and inspected on a regular basis.
2.Abrasive cleaners will damage this product.
3.Never use oven cleaner to clean any part of grill.
Before Each Use:
1.Keep the grill area clean and free from any combustible materials, gasoline and other flammable vapors or liquids.
2.Do not obstruct the flow of the combustion of LP and the ventilation air.
3.Keep the ventilation opening(s) of the LP gas tank area free and clear from debris.
4.Visually check the burner flames to make sure your grill is working properly.
5.See sections below for proper cleaning instructions.
6.Check and clean the burner/venturi tubes for insects and insect nests. A clogged tube can lead to a fire beneath the grill.
Cleaning Surfaces
Figure 21
Burner Flame Conditions
Use this chart check to see if your
burners need to be cleaned.
- 50.8 mm | |
1 | 25.4 |
- 50.8 mm | |
1 | 25.4 |
Normal: Soft blue flames with yellow tips between 1 in. - 2 in. hight.
Needs Cleaning: Noisy with hard blue flames.
Has to be cleaned: Wavy with yellow flames.
3.Lightly coat the burners with cooking oil to prevent excess rusting.
4.LP: If storing the grill indoors, disconnect the LP tank, see “Disconnect LP Gas Tank” section, and leave the LP gas tank OUTDOORS.
NG: If storing the grill indoors, disconnect the grill, see “Disconnect Natural Gas Line” section.
5.Place the protective cap cover on the LP tank and store the tank outdoors in a well ventilated area out of direct sunlight.
6.If storing the grill outdoors, cover the grill with a grill cover for protection from the weather.
Product Registration
For faster warranty service, register your product immediately at www.bluerhino.com or call 1.800.762.1142.
Limited Warranty
Blue Rhino Global Sourcing, Inc (“Vendor”) warrants to the original retail purchaser of this product, and to no other person, that if this product is assembled and operated in accordance with the printed instructions accompanying it, then for a period of one (1) year from the date of purchase, all parts in such product shall be free from defects in material and workmanship. Vendor may require reasonable proof of your date of purchase. Therefore, you should retain your sales slip or invoice. This Limited Warranty shall be limited to the repair or replacement of parts, which prove defective under normal use and service and which Vendor shall determine in its reasonable discretion upon examination to be defective. Before returning any parts, you should contact Vendor’s Customer Service Department using the contact information listed below. If Vendor confirms, after examination, a defect covered by this Limited Warranty in any returned part, and if Vendor approves the claim, Vendor will replace such defective part without charge. If you return defective parts, transportation charges must be prepaid by you. Vendor will return replacement parts to the original retail purchaser, freight or postage prepaid.
This Limited Warranty does not cover any failures or operating difficulties due to accident, abuse, misuse, alteration, misapplication, improper installation or improper maintenance or service by you or any third party, or failure to perform normal and routine maintenance on
the product as set out in this owner’s manual. In addition, the Limited Warranty does not cover damage to the finish, such as scratches, dents, discoloration, rust or other weather damage, after purchase.
This Limited Warranty is in lieu of all other express warranties. Vendor disclaims all warranties for products that are purchased from sellers other than authorized retailers or distributors,
1.Wipe surfaces clean with mild dishwashing detergent or baking soda mixed with water.
2.For stubborn surfaces use a citrus based degreaser and a nylon scrubbing brush.
3.Rinse clean with water.
4.Allow to air dry.
Cleaning Main Burners
1.LP: Make sure control knobs are in the 
(OFF) position and LP gas tank valve to “CLOSED”.
NG: Make sure control knobs are in the 
(OFF) position and NG valve to “OFF”.
2.Remove cooking grids and heat plates.
3.Remove burners by removing the fasteners securing the burner to the grill bottom.
4.Lift burners up and away from gas valve orifice.
5.Disconnect wire from spark electrode.
6.Clean inlet (venturi) of burners with small bottle brush or compressed air.
7.Remove all food residue and dirt on burner surfaces.
8.Clean any clogged ports with a stiff wire (such as an opened paper clip).
9.Inspect burners for any damage (cracks or holes). If damage is found, replace with new burner(s) from manufacturer.
10.Reinstall burners, check to insure that the gas valve orifices are correctly positioned inside burner inlets (venturi). Check position of spark electrode.
11.Replace heat plates and cooking grids.
12.Perform leak test. See “Checking for Leaks”.
Cleaning Side Burner
1.LP: Make sure control knobs are in the 
(OFF) position and LP gas tank valve to “CLOSED”.
NG: Make sure control knobs are in the 
(OFF) position and NG valve to “OFF”.
2.Remove side burner grid.
3.Remove burner by removing the screws securing the burner to the side shelf.
4.Lift burner up and away from gas valve orifice.
5.Clean inlet (venturi) of burner with small bottle brush or compressed air.
6.Remove all food residue and dirt on burner surface.
7.Clean any clogged ports with a stiff wire (such as an opened paper clip)
8.Inspect burner for any damage (cracks or holes). If damage is found, replace with new burner from manufacturer.
9.Reinstall burner, check to insure that gas valve orifice is correctly positioned inside burner inlet (venturi). Also check position of spark electrode.
10.Replace side burner grid.
11.Perform leak test. See “Checking for Leaks”.
Before Storing
1.LP: Make sure control knobs are in the 
(OFF) position and LP gas tank valve to “CLOSED”.
NG: Make sure control knobs are in the 
(OFF) position and NG valve to “OFF”.
2.Clean all surfaces.
including the warranty of merchantability or the warranty of fitness for a particular purpose.
VENDOR ALSO DISCLAIMS ANY AND ALL IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. VENDOR SHALL HAVE NO LIABILITY TO PURCHASER OR ANY THIRD PARTY FOR ANY SPECIAL, INDIRECT, PUNITIVE, INCIDENTAL, OR CONSEQUENTIAL DAMAGES. Vendor further disclaims any implied or express warranty of, and assumes no responsibility for, defects in workmanship caused by third parties.
This Limited Warranty gives the purchaser specific legal rights; a purchaser may have other rights depending upon where he or she lives. Some jurisdictions do not allow the exclusion or limitation of special, incidental or consequential damages, or limitations on how long a warranty lasts, so the above exclusion and limitations may not apply to everyone.
Vendor does not authorize any person or company to assume for it any other obligation or liability in connection with the sale, installation, use, removal, return, or replacement of its equipment, and no such representations are binding on Vendor.
Blue Rhino Global Sourcing, Inc