WIRING
All wiring should conform to the National Electrical Code. Install a separately fused disconnect switch for the water heater. The water heater is equipped with an immersion aquastat with dual bulbs to control operation of the heater and a separate high limit immersion control (both controls are installed and wired at the factory). A wiring harness is furnished to connect the control system to the burner control panel. Follow the wiring diagram furnished with the burner to complete the field wiring.
When wiring is completed, set the operating temperature control (L8100C) to 120°F. Higher temperature setting will increase the risk of scalding.
WIRING DIAGRAM: LARGE OIL W/AVERAGING
P.F. GAS BURNER WIRING W/AVG.