Bogen UDMS16HH, UDMS16BP instruction manual UBP16 BODYPACK MICROPHONE TRANSMITTER

UBP16 BODYPACK MICROPHONE TRANSMITTER

1.Open the BATTERY DOOR (30) by pulling on side tabs and swinging the lid open.

Insert two fresh AAA ALKALINE BATTERIES into the BATTERY COMPARTMENT. (31), observing the correct polarity. Fresh alkaline batteries can last up to 5 hours in use, but in order to ensure optimum performance, it is recommended that the batteries be replaced after 3-4 hours of use.

2.The UBP16 is provided with a 3.5 mm LOCKING JACK (33) for connecting the audio input. Connect the LAVALIERE MIC CORD (40) here. To secure the connection, turn the slip ring on the plug clockwise to thread it on the jack. To unplug, reverse the process. Slip the transmitter into a pocket or use the CLIP (32) on the rear of the unit to attach to your clothes.

3.Select Channel by turning the frequency rotary DIP switch (39) to one of the sixteen channels. The slot on the switch shaft should match a number or letter of the dial, which indicates the selected channel. This channel needs to be set to the same channel as the UDR16 Receiver. (IMPORTANT NOTE: The transmitter must be OFF when selecting a new channel. When selected, the transmitter will then be at the new selected channel when turned ON. If you attempt to change the channel when the transmitter is ON, it will not change until the unit is turned OFF and ON again. This step must be repeated each time you select a new channel.)

4.Turn on the UBP16 by sliding the AUDIO MUTE SWITCH (34) to the OFF position first, then slide the POWER SWITCH (36) to the ON position. The bi-color LED. indicator (35) will stay ON (green) indicating usable battery strength and the transmitter is ON. In the case of dead or low batteries, the LED will either not go on at all or will stay ON (red) continuously, indicating that the batteries should be replaced with fresh ones. To preserve battery life, turn the transmitter OFF when not in use. The A or B Diversity LED indicators (14). on the UDR16 receiver should now be lit, indicating that signal is being received from the transmitter.

(Note: The UBP16 is supplied with a removable antenna (37). It should always be operated with the supplied antenna. For optimum operating range, always maintain line-of-sight between the transmitter and the receiver whenever possible.)

5. Microphone Use

Secure the connection from the LAVALIERE MIC CORD (40).To use the lavaliere mic, attach it at chest level. Do not place it too close to the mouth. A distance of about six inches usually works best. When ready to speak, slide the AUDIO MUTE SWITCH (34) to the ON position.

8