Bogen UDMS16BP, UDMS16HH instruction manual UHT16 HANDHELD MICROPHONE TRANSMITTER

UHT16 HANDHELD MICROPHONE TRANSMITTER

1.Install batteries by unscrewing the BATTERY COMPARTMENT COVER (28). counterclockwise and remove, exposing the BATTERY HOLDER (26). Insert two fresh AA ALKALINE BATTERIES (27), observing the correct polarity, and screw the cover back on to the microphone. Make sure the cover is screwed clockwise completely. Fresh alkaline batteries can last up to 10 hours in use, but in order to ensure optimum performance, it is recommended that you replace the batteries after every 7-8 hours of use.

2.Select Channel by turning the frequency rotary DIP switch (20) to one of the sixteen channels. The slot on the switch shaft should match a number or letter of the dial, which indicates the selected channel. This channel needs to be set to the same channel as the UDR16 Receiver. (IMPORTANT NOTE: The transmitter must be OFF when selecting a new channel. When selected, the transmitter will then be at the new selected channel when turned ON. If you attempt to change the channel when the transmitter is ON, it will not change until the unit is turned OFF and ON again. This step must be repeated each time you select a new channel.)

3.Turn on the UHT16 by sliding the AUDIO MUTE switch (21) to the OFF position first.

Then slide the power switch (22) to the ON position. The TX LED indicatoR (green)

(23) will stay on to indicate that the transmitter is on. The battery indicator. LED (red) (24) will stay OFF, indicating usable

battery strength. In the case of a dead	25
or low battery, the battery indicator.	26	27
LED (24) will either not go on at all or
will stay on continuously, indicating
that the batteries should be replaced with
fresh ones. To preserve battery life, turn		20
the transmitter off when not in use.
	21
4. The microphone is now ready to use. The		22
A or B DIVERSITY LED INDICATOR (14) on the	28	24 23
UDR16 receiver should now be lit, indicating

a received signal from the transmitter. When ready to speak, slide the AUDIO switch (21).

totheONposition.(Note:ObservecareinselectingP.A.volume,transmitterlocation and speaker placement so that acoustic feedback (howling or screeching) will be avoided.) (Note: The windscreen of the UHT16 functions as a built-in antenna. For proper operation, never remove the windscreen during use, or exchange with another type. For optimum range, maintain line-of-sight between the transmitter and the receiver whenever possible. Holding the microphone tightly, bridging across the windscreen and mic tube, will also lessen range. Hold mic by mic tube housing only for optimum operation.)

5.For optimum performance, an INPUT LEVEL CONTROL (25) is provided. Adjust the gain by turning the control with a small screwdriver. It is recommended that the level be set at about 1/2 maximum. Experiment and set for maximum possible gain without audible distortion on the high level peaks. (Note: Turning down the gain too much can compromise the signal-to-noise ratio, and is not recommended.)

7