PBX Page Port VOX
In this configuration, the unit activates when audio on the page input is detected. Loss of audio allows the VOX timer to expire and ends the page.
Make sure that the power is disconnected and all other connections are completed before proceeding. Move the slide switches on the UTI1 to the positions shown below. Use a modular telephone cord to connect the module to the phone system. The center two conductors are used for dry audio and are not polarity sensitive. The Trunk disconnect feature is not available in this mode.
PBX Analog Station Port
In this configuration, the unit answers after detecting ring. As soon as it answers, the default timer and VOX timer are started.The default timer determines the maximum length of any page.The VOX timer repeatedly resets as long as audio is detected on the line. If no audio is detected within the VOX time period, then the page will end. If audio continues to be detected, then the default timer will control page length. The unit will disconnect if a loss of loop current is detected.
Make sure that the power is off and all connections are completed before proceeding. Move the interface slide switch on the UTI1 to STATION. The other interface slide switch is not used and can be in any position. Use a modular telephone cord (minimum
Note:The default timeout is factory set to 30 seconds, and the VOX timeout is set to 6 seconds. If both the default and VOX timers are inhibited, the only way to release the system from the station line is through the use of a Calling Party Control (CPC) pulse.
9
