Bogen UTI312 specifications Flexible Dialing Reference Chart

Flexible Dialing

Flexible Dialing permits the user to custom configure the digit length and the access codes for zones and paging zone groups.

The digit length for Flexible Dialing can be set to 2, 3, 4 or 5 digits.When Flexible Dialing is enabled, zones and paging zone groups are the same digit length and no * is used for accessing zone groups. Duplicate Flexible Dialing numbers are not permitted.

Note:The digit length cannot be changed unless the user-programmed access codes have been cleared first.

When Flexible Dialing is enabled, a zone or paging zone group cannot be accessed until a Flexible Number has been assigned to it.

When Flexible Dialing is disabled, the unit uses the default access codes for zones and paging zone groups (01 through 12 for zones and *01 through *24 for paging zone groups). Disabling Flexible Dialing will not clear any user-programmed access codes or the digit length setting. Flexible Dialing does not need to be enabled to program the digit length or the new access codes for zones and paging zone groups. However, the new access codes are functional only in Run mode and cannot be accessed in Program mode.When programming paging zone groups, the default zone groups (*01 through *24) must be used.

To program the UTI312 system for Flexible Dialing, follow these instructions:

1. Use the table below to list and cross-reference the new Flexible Dialing Plan numbers before programming.

2.If this is the first time this feature has been programmed, then begin by setting the digit length (codes 062-065). If this is not the first time this feature has been programmed, then begin by clearing all user-programmed access codes (code 900#) and then set the digit length.

3.Dial the Feature Code (codes 101-224) and then the desired Flexible Dialing Number for that particular zone or paging zone group.

4.Press the [#] key to store the programming data. If you don’t dial the [#] key, then the data is not stored. A double beep will sound to confirm the entry.

5.When finished programming all of the Flexible Dialing Numbers for the zones and the paging zone groups, enable Flexible Dialing (code 061).

6.Once you have finished all programming, you must first hang up the programming phone and then place the Program/Run switch in the Run position.The green LED will go out.

Flexible Dialing Reference Chart

Zones	Flexible
	Dialing #

Zone 1

Zone 2

Zone 3

Zone 4

Zone 5

Zone 6

Zone 7

Zone 8

Zone 9

Zone 10

Zone 11

Zone 12

Paging Zone	Flexible	Paging Zone	Flexible
Groups	Dialing #	Groups	Dialing #
Zone Group 1		Zone Group 13
Zone Group 2		Zone Group 14
Zone Group 3		Zone Group 15
Zone Group 4		Zone Group 16
Zone Group 5		Zone Group 17
Zone Group 6		Zone Group 18
Zone Group 7		Zone Group 19
Zone Group 8		Zone Group 20
Zone Group 9		Zone Group 21
Zone Group 10		Zone Group 22
Zone Group 11		Zone Group 23
Zone Group 12		Zone Group 24

22