Installation
Mounting
Wall Mounting
Mounting to a plywood backboard or studs:
1. On each side remove the four screws in the corners and use them to attach the mounting flanges so that the flanges are facing the rear of the unit.
2.Hold the unit level against the surface to which it will be mounted.
3.Using the keyholes, mark on the mounting surface where the mounting screws (not included) should be positioned.
4.Set the unit aside and install the screws leaving about 1/4" of the screws sticking out of the surface.
5.Slip the unit over the screws through the keyholes and let the unit rest on the screws.Tighten screws snugly.
Rack Mounting, Flush
Mounting flush to a rack:
1. On each side remove the four screws in the corners and use them to attach the mounting flanges so that the flanges are facing the front of the unit.
2.Attach unit to rack with 4 rack screws (not supplied). Do not use keyholes for mounting to a rack.
Rack Mounting, Recessed for Wire Access
Recessed in a rack to allow for top or bottom wire entry:
1. On each side remove the four screws in the corners and use them to mount the mounting flanges so that the flanges are protruded from the front of the unit.This recess allows enough space for wire access from top or bottom.
2.Attach unit to rack with 4 rack screws (not supplied). Do not use keyholes for mounting to a rack.
ZX3 Module Installation & Jumper Selections
The UTI312 module bay can accommodate up to four ZX3 modules. Each ZX3 module has 3 zone outputs giving the UTI312 a capacity of up to 12 paging zones.
Each module slot is marked on the lower left hand corner indicating which zones correspond with each slot.
To install, first select each zone’s Music Bus A or B or (no music) using the jumpers, then slide the ZX3 module into the card guides and push the module all the way home. Secure with mounting screws.
Wall Mounting
Rack Mounting, Flush
Rack Mounting,Wire Access
ZX3 BGM Jumper Selections
6
