Bogen VMIX specifications Operation, Front Panel Controls & Indicators

Operation

Front Panel Controls & Indicators

Input Volume Controls and Signal / Clip Indicator

Each input module may be individually controlled by its corresponding volume control knob.A single LED located above each channel’s volume control indicates the audio activity of that channel’s input. Green indi- cates signal present at the input. Red indicates that the input signal com- ing from the input module into the mixer is clipping and distorted. This is caused by either an input signal that is too high or an input module volume control (gain) that is set too high.

Bass and Treble Controls

The treble control has a cut/boost range of +/- 10 dB at frequencies above 10 kHz and provides a roll off after 20 kHz to reduce gain above the audio range.The bass control has a cut/boost range of +/- 10 dB at frequencies below 100 Hz.

Master Volume Control

The overall volume level of the mixer is set by a Master Volume control. The Master Volume control is motorized and can be controlled by man- ually adjusting the knob or by a remotely-mounted control station. Connections and requirements for the remote control station are described in the Connections section, under Remote Volume Control.

Peak Hold Switch & LED Output Meter

The LED Output Meter is an 11-segment meter with a defeatable peak hold function. When the peak hold is “on”, any meter indication of “0” or above will temporarily remain while the meter continues to indicate the instantaneous signal level.

Power Switch / Power Indicator

The AC power to the amplifier is controlled by the Power rocker switch. A red LED indicator lights to confirm the power on status of the mixer.

8