Speaker Installation

STEP 1 - Mark the point from which to hang the speaker. Drill an appropriately sized hole in the wall and insert an anchor. Drive the screw into the anchor leaving enough of the screw exposed from which to hang the speaker on. See Figure 3.

NOTE: Wall baffle speakers should be installed between 8 and 16 feet from the floor depending upon need.

STEP 2 - Make the electrical connections using the 2 screw ter- minals on the WB1EZ. The recommended amplifier connections are:

(+)70V terminal - 70V HOT

(-)COM terminal - 70V COMMON

NOTE: The speaker will also work perfectly well with these connections reversed. However, it is important to be consistent in the wiring of the speakers in the system.

If adjacent speakers have reversed wiring connections, they will tend to cancel each other’s bass response, thereby diminishing the sound quality.

STEP 3 - If it is necessary to adjust the volume, insert a thin, flat blade screwdriver into the access hole at the bottom of the wall baffle, then turn the volume control clockwise (as viewed from the bottom of the baffle) to increase the volume. To reduce the vol- ume, simply turn the volume control in a counterclockwise motion. See Figure 4.

Figure 3

WALL

ANCHOR

Figure 4

BACK OF SPEAKER

BOTTOM

RECESSED VOLUME CONTROL

OF SPEAKER

Turn in a clockwise motion

 

 

to increase volume.

50 Spring Street, Ramsey, NJ 07446

Tel. (201) 934-8500 / Fax: (201) 934-9832

54-5069-01 Printed in Korea 9904

© 1999 Bogen Communications Inc. All rights reserved. Specifications subject to change without notice.

www.bogen.com

Page 2
Image 2
Bogen WB1EZ manual Speaker Installation, + 70V terminal 70V HOT COM terminal 70V Common, Turn in a clockwise motion