Bolens 13885-8, 13875-8 manual y~GI, it CAUTION, a:::I-4--F~, @Ci:I, I Ie, P.S.I

Limited Warranty.		2			12Adjustment
Safe Operation	Practices	3
					13
Index.		4
			Belt Removal.		15
Assembly.		5
			Illustrated	Parts for Rider.	20,22,24,26
Battery Information.		5	Parts Lists	for Rider.	21, 23, 25, 27
Before Starting	Engine.	7	Illustrated	Parts for Transaxle	28
Controls.		8
			PartsListforTransaxle		29
Operation of Controls.		9
			Electrical Diagram.		30Parts
Cutting Tips.		11
			Information.		Back Cover
Lubrication		12

GRASS CATCHER Model No. 19014-8 is available as optional equipment Tor the mowers shown in this manual.

+t

The mower should not be operated without the entire grass catcher or chute deflector in place.

NOTE

Under normal usage bag material is subject to wear, and should be checked periodically. Be sure any

replacement bag complies with the mower manufacturer's recommen- dations.

For replacement bags, use only fac- tory authorized replacement bag No. 764-0157

_IMPORTANT

After striking a foreign object, stop the engine. Remove wire from spark

plug, thoroughly inspect the mower for any damage, and repair the dam-

age before restarting and operating the mower.

The steering wheel and seat, witn the necessary hardware, are easily assembled to the machine. On the electric starter models, the battery must be activated and installed as outlined in this section.

TIRE PRESSURE

FOR SHIPPING PURPOSES, THE TIRES ON YOUR UNIT MAY BE OVER-INFLATED. TIRE PRESSURE SHOULD BE REDUCED BEFORE UNIT IS PUT INTO OPERATION. PRESSURE SHOULD BE APPROXIMATEl Y.15 P.S.I. EQUAL TIRE PRESSURE SHOULD BE MAINTAINED ON All TIRES. MAXIMUM TIRE PRESSURE IS 30

P.S.I.

4

I=I~D(~~(I]J""Maintenance.-F .

it CAUTION

Installation of tire to rim:

1. Lubricate tire beads and rim flanges.

2.Do not exceed 30 P.S.I. when seating beads.

3.Adjust to recommended pressure after beads are sealed.

NOTE

Reference to right-hand or left-hand side of machine is from the driver's seat facing forward.

List of Contents in Hardware Pack.
See figure			1 .
A	(1)	Spring Pin		Spiral 1/4" Dia.	x 1.00" Long
B	(1)	Lockwasher		V2" Screw	~
C	(1)	~l
		Hex	Nut V2-13 Thread
				1
		A.	B	c		~
				@CI:I)	ra
					E B

a:::I)-4--F~

y~GI

a=D

/I Ie

FIGURE 1. HARDWARE SUPPLIED