3. Place the battery hold down over battery and secure in place with hex screws (0) 5V2 inches long, lockwashers (E), and hex nuts (F). See figure 7.
Attach the positive cable (right hand side of rider) to the positive battery terminal with hex sems screw (G) and hex nut (F). See figure 8.
Attach the negative cable, grounded, to the negative battery terminal with hex sems screw
(G) and hex nut (F). See figure 8.
FIGURE 5. REMOVE BATTERY ACCESS PANEL
2.Place battery in battery terminals to the front of terminal will be on the left See figure 6.
case with the unit. Negative
FIGURE 8.
Battery cable connections must be kept tight on
the terminals to provide a good contact. To prevent corrosion of the terminals, a light coat of petroleum jelly should be applied.
Replace battery access panel.
FIGURE 6.
FIGURE7.
7
PUT OIL IN CRANKCASE See figure 9.
Place the tractor on a level surface. Remove the oil
fill plug and fill the sump to overflowing. Pourslowly. Sump capacity is 3 pints.
For use in temperatures above 40°F, use SAE 30, SAE
For temperatures under OaF, see the engine manual or consult a certified service center for proper engine treatment.
Use a high quality, detergent oil classified "For service SC, SO, SE or MS". Nothing should be added to the recommended oil.
654.
