Electric Starter (If Equipped)

WARNING: The electric starter is equipped with a grounded three-wire power cord and plug and is designed to operate on 120 volt AC household current. It must be used with a properly grounded three-prong receptacle at all times to avoid the possibility of electric shock. Follow all instructions carefully prior to operating the electric starter.

•Determine that your house wiring is a three-wire grounded system. Ask a licensed electrician if you are not certain.

•If your house wiring system is not a three-wire grounded system, do not use this electric starter under any conditions.

•If your home electrical system is grounded, but a three-hole receptacle is not available, one should be installed by a licensed electrician before using the electric starter.

•If you have a grounded three-prong receptacle, proceed as follows:

•Rotate choke knob to OFF position and do not prime engine.

•Connect power cord to switch box on engine. Plug the other end of power cord into a three-hole, grounded 120 volt AC receptacle.

•Push starter button on top of the engine to crank engine. As you crank the engine, move choke knob to FULL choke position.

•When engine starts, release starter button, and move choke gradually to OFF. If engine falters, move choke immediately to FULL and then gradually to OFF.

•When disconnecting the power cord, always unplug from the three-prong receptacle first and then from the snow thrower.

Recoil Starter

•Rotate choke knob to FULL choke position (cold engine start). If engine is warm, place choke in OFF position instead of FULL.

•Push primer button two or three times. If engine is warm, push primer button once only.

NOTE: Always cover vent hole in primer button when pushing. Additional priming may be necessary for first start if temperature is below 15°F.

•Grasp starter handle and pull rope out slowly, until it pulls slightly harder. Let rope rewind slowly.

•Pull starter handle rapidly. Do not allow handle to snap back. Allow it to rewind slowly while keeping a firm hold on the starter handle.

•Repeat the previous steps until engine starts.

To Stop Engine

•Run engine for a few minutes before stopping to help dry off any moisture on the engine.

•To help prevent possible freeze-up of starter, proceed as follows.

Electric Starter:

•Connect power cord to switch box on engine, then to 120 volt AC receptacle. With the engine running, push starter button and spin the starter for several seconds. The unusual sound made by spinning the starter will not harm engine or starter. Disconnect the power cord from receptacle first, and then from switch box.

Recoil Starter

•With engine running, pull starter rope with a rapid, continuous full arm stroke three or four times. Pulling the starter rope will produce a loud clattering sound, which is not harmful to the engine or starter.

•Move throttle control to “stop” or “off” position.

•Remove ignition key. Do not turn key. Disconnect the spark plug wire from the spark plug to prevent accidental starting while equipment is unattended.

NOTE: Keep it in a safe place. Engine will not start without ignition key.

•Wipe all snow and moisture from the carburetor cover in the area of the control levers. Also, move control levers back and forth several times.

To Engage Drive

•With the engine running near top speed, move shift lever into one of the six FORWARD positions or two REVERSE positions. Select a speed appropriate for the snow conditions that exist.

NOTE: Use slower speeds until you are familiar with the operation of the snow thrower.

•Squeeze the traction control against the right handle and the snow thrower will move. Release it and the drive motion will stop.

IMPORTANT: NEVER move shift lever without first releasing the traction control. Doing so will cause premature wear to drive system’s friction wheel rubber.

To Engage Augers

To engage the augers and start the snow throwing action, squeeze the auger control against the left handle.

To disengage power to the augers, release both the auger control and the traction control, if engaged.

Tire Chains (If Equipped)

Tire chains should be used whenever extra traction is needed.

9

Page 8 Page 10
Page 9
Image 9
Bolens 750, 550 manual Electric Starter If Equipped, Recoil Starter, To Stop Engine, To Engage Drive, To Engage Augers
Page 8 Page 10

750, 550 specifications

The Bolens 750 and 550 are robust garden tractors renowned for their reliability and performance in lawn care and gardening tasks. Designed for both amateur and professional gardeners, these machines provide an exceptional blend of power and versatility.

The Bolens 750 features a powerful engine, typically a 17-20 HP Briggs & Stratton or Kohler, known for their durability and efficient fuel consumption. This tractor is fitted with a hydrostatic transmission system, which ensures smooth operation and ease of use. The hydrostatic system allows the user to control speed and direction effortlessly, making it an ideal choice for navigating tight spaces and varied terrains.

On the other hand, the Bolens 550 offers a slightly lower horsepower, usually around 15 HP, but maintains many of the same core features found in its counterpart. The 550 is designed for users who may need a more compact option without sacrificing performance. Both tractors have a rugged steel frame construction, ensuring longevity and strength, even when subjected to heavy-duty tasks.

A major highlight of both models is their cutting deck, available in various sizes, from 42 inches up to 54 inches. The adjustable cutting height feature allows users to set the desired grass length, providing flexibility for different lawn types and personal preferences. The side discharge option efficiently handles grass clippings, while mulch kits are also available for those who prefer returning nutrients to the soil.

One significant technological advancement in the Bolens 750 and 550 models is their ergonomic design. The comfortable seating, well-placed controls, and easy access points for maintenance make these tractors user-friendly. With a tight turning radius, they excel in maneuverability, making them suitable for properties with intricate landscaping.

Moreover, both tractors come equipped with standard rear and front hitch capabilities, allowing for the attachment of various accessories, such as snow plows, tillers, and aerators. This versatility makes them indispensable tools for year-round yard care and maintenance.

In summary, the Bolens 750 and 550 stand out with their powerful engines, innovative features, and rugged build quality. They cater to a variety of gardening and landscaping needs, offering users unmatched reliability and efficiency in their outdoor tasks. Whether you are tackling expansive gardens or compact lawns, these tractors deliver performance that can help transform any landscape with ease and precision.
Top Page Image Contents