Auger Control
�����
�������
��
The auger control is located on the left handle. Squeeze the control grip against the handle to engage the augers and start snow throwing action. Release to stop.
Drive Control
�����
�������
��
The drive control is located on the right handle. Squeeze the control grip against the handle to engage the wheel drive. Release to stop.
Chute Directional Control
�������������������������
|
| ���������� |
��������� | ��������� | ���������� |
���� | ����� |
|
The chute directional control is located on left side of the snow thrower.
To change the direction in which snow is thrown, turn chute directional control as follows:
•Crank clockwise to discharge to the left.
•Crank counterclockwise to discharge to the right.
Ignition Key
The ignition key is a safety devise. It must be fully inserted in order for the engine to start. Remove the ignition key when the snow thrower is not in use. Do not turn the ignition key in an attempt to start the engine. Doing so may cause it to break.
WARNING: Never use your hands to clear a clogged chute assem- bly. Shut off engine and remain behind handles until all moving parts have stopped before unclogging.
The chute
NOTE: This item is fastened with a cable tie to the rear of the auger housing at the factory. Cut the cable tie before operating the snow thrower.
Skid Shoes
Position the skid shoes based on surface conditions. Adjust upward for
Recoil Starter Handle
This handle is used to manually start the engine.
Electric Starter Button
Pressing the electric starter button engages the engine’s electric starter when plugged into a 120V power source.
Electric Starter Outlet
Requires the use of a
Augers
When engaged, the augers rotate and draw snow into the auger housing.
Chute Assembly
Snow drawn into the auger housing is discharged out the chute assembly.
Gas Cap
Unthread the gas cap to add gasoline to the fuel tank.
4
Operating
Your Snow
Thrower
WARNING
The operation of any snow thrower can result in foreign objects being thrown into the eyes, which can damage your eyes severely. Always wear safety glasses while operating the snow thrower, or while performing any adjust- ments or repairs on it.
Be sure no one other than the operator is standing near the snow thrower while starting engine or operating snow thrower. Never run engine indoors or in enclosed, poorly ventilated areas. En- gine exhaust contains carbon monoxide, an odorless and deadly gas. Keep hands, feet, hair and loose clothing away from any moving parts on engine and snow thrower.
9
