Bosch Appliances 5000, 7000 3.3Mounting the DINION capture, 20 en | Installing the DINION capture

20 en Installing the DINION capture DINION capture 5000/7000

3.3Mounting the DINION capture

CAUTION!

Installation should only be performed by a qualified service professional in accordance with the National Electrical Code or applicable local codes.

For a secure mounting installation, bolts should extend through the mounting surface and be secured with nuts, washers, and lock washers on the opposite side. If studs are used, they should be anchored in concrete or welded to a steel backer plate.

Refer to the MBE Mounts and Adapters Installation Guide for more details about attaching the bracket to an MBE-15 Pole Mount Adapter or to the MBE-17 Wall Mount Adapter.

1.Use the wall mount template supplied in the packaging box to locate the four mounting holes for the camera bracket.

2.Drill four (4) holes for the mounting bolts. If installing outdoors, apply a weatherproof sealant around each hole at the mounting surface.

3.Route the cable. If routing the cable through the wall, drill a 25.4 mm (1 in.) hole following the wall mount template and use a weatherproof sealant to seal around the cable to ensure a weather tight seal between indoors and outdoors, otherwise route the cable through one of the side holes in the mounting bracket by removing the plug and routing the cable through.

(Routing cables through a side hole in the bracket and into a near junction box makes setup and troubleshooting simpler.)

WARNING!

A stud/bolt diameter of 6.0 mm (or 1/4 inch) able to withstand a 300 kg (660 lb) pull-out force is recommended. The mounting material must be able to withstand this pull out force.

1.0 2012.01 Installation Manual Bosch Security Systems, Inc.