24 en Installing the DINION capture | DINION capture 5000/7000 |
|
|
3.5Making the Connections
WARNING!
Before proceeding, disconnect the DINION capture from the power supply. Ensure that the voltage of the unit matches the voltage and type of the power supply being used.
The easiest way to connect the cables is as follows:
1.Bring the building connections through the surface cable hole so that they hang clear.
2.Connect the BNC connector of the license plate camera module to the video coax cable. For the DINION capture 7000, connect a video coax cable to the video output cables for both the license plate camera (white cable) and for the overview camera (red cable).
3.Connect the ferrule tipped power wires (red, black; polarity independent) from the license plate camera to the power supply connection.
4.In damp environments ensure that the connections are sealed inside a junction box or a field wiring box with NEMA 3 or IP55 protection level or better. Make the connections inside the water tight compartment. After connections are made, ensure that the watertight compartment is tightly closed and cables and conduits are properly sealed to prevent ingress of water.
3.6Automatic Mode Switching
Automatic Mode Switching is a feature on the license plate camera that automatically compensates for bright conditions. Automatic Mode Switching, by default, operates by switching from Mode 1 (Normal) to Mode 2 (FullSun) when the ambient light levels rise above normal conditions (for example, bright sunlight on the scene). Automatic Mode Switching is inactive by default and requires setup to operate as desired.
In most conditions, Automatic Mode Switching may not be necessary. Activate the switch only if the license plate camera
1.0 2012.01 | Installation Manual | Bosch Security Systems, Inc. |
