DINION capture 5000/7000 | Installing the DINION capture en 21 |
|
|
4.Secure the mounting bracket to the mounting surface. Use four (4) corrosion-resistant, stainless steel studs or bolts, nuts, washers, and lock washers (not supplied).
5.Adjust the license plate camera angle using the range and angle recommendations in Section 3.1 Determining the Range, page 17.
–Connect the imager to a local monitor to assist adjusting the license plate camera.
6.Adjust the tilt angle of the camera by loosening the tilt bolt (item 1, below) with the 5 mm hex key and the set screw (item 2) with a flat head screwdriver.
7.Place the license plate camera at the desired tilt angle and tighten the tilt bolt and the set screw.
8.Adjust the pan angle of the camera by loosening the pan bolt, located beneath the bracket mounting head, by loosening the pan bolt using the 5 mm hex key. Place the license plate camera at the desired pan angle and tighten the bolt.
Bosch Security Systems, Inc. | Installation Manual | 1.0 2012.01 |
